Examples of 'μs' in a sentence
Meaning of "μs"
μs (noun) - Symbol for 'microsecond', a unit of time equal to one millionth of a second
How to use "μs" in a sentence
Basic
Advanced
μs
Its symbol is μs.
Pulse duration" exceeding 1 μs and any of the following.
Abbreviated as μs.
In addition, no contact interruptions > 1 μs are permitted during the test.
The trigger signal should last more than 5 μs.
Radar pulses lasting 2 μs were broadcast from a 50 ft diameter radio dish.
Setting, changing and confirming the number of cycles μs microseconds.
This recovery process takes 25 to 75 μs and limits thyratron repetition rates to a few kHz.
Spatial resolution of a shaped solid, Resolution in time ms or μs.
Several methods have been proposed to achieve a latency of 5 μs desired in the C-RAN context.
Pulses from this system are now tracked to within 15 μs.
Turn on time of 1 μs or less.
High-precision signal acquisition at resolutions up to 1 μs.
A pulsed output having a "pulse duration" exceeding 10 μs and having any of the following.
Double distilled water or water of equivalent quality must be used conductivity < 10 μS.
See also
Synchronized within 1 μs accuracy.
Returning to normal operating mode from software standby mode takes a mere 4.8 μs.
CENTER Servo centre in μs If active ( highlighted ), according to transmitter control position.
For the anodes to function properly, the water requires a minimum conductivity of 150 μs.
Pulsed output with a "pulse duration" exceeding 10 μs and any of the following.
The controller achieves cycle times of up to 400 μs.
Capable of delivering their energy in less than 15 μs into loads of less than 40 ohms ;.
The total duration of the line is 64 μs.
In Nominal current Peak current in 8/20 μs waveform the protection device can withstand 20 times.
It is desirable to obtain a conductivity equal to 300 μS.
Pulse duration" not exceeding 1 μs and output energy exceeding 50 J per pulse; or.
It is desirable to obtain a conductivity value of 300 μS.
Response delay 50 μs nominal for channel X 56 μs nominal for channel Y.
Maximum total time of an irradiation was of t 1.5 μs.
An electronic shutter speed ( gating capability ) of less than 1 μs per full frame ; and.
Precision timing, exact synchronisation in < 1 μs.
The opto-isolator must be a high-speed type, with less than 2 μs risetime.
When a command calls for a response, the device is expected to respond in 30 to 80 μs.
