Examples of 'addition rate' in a sentence
Meaning of "addition rate"
addition rate - The speed or frequency at which something increases, augments, or is added to a particular context. It can refer to the rate of additional or supplementary elements being included
How to use "addition rate" in a sentence
Basic
Advanced
addition rate
The addition rate was adjusted to control the exotherm.
Once crystals formed the addition rate could be increased.
The addition rate was slow enough to prevent solvent reflux.
Polymer molecular weight was controlled by variation of hydrogen addition rate.
The addition rate was carefully controlled to avoid formation of a gummy precipitate.
We would then bring the stock addition rate under control.
The addition rate was adjusted as earlier indicated to control the exotherm.
Reaction progress was monitored by titrant addition rate and sampling at intervals.
The addition rate was adjusted to maintain gentle reflux of the mixture.
The foaming was minimized by slowing the addition rate of the sulfuric acid.
The addition rate was controlled to avoid obvious boiling of the resulting solution.
A pressure demand control valve system was used to control the addition rate.
A higher rotating speed with a lower addition rate will incorporate more air.
The temperature is controlled by a heat sink or by adjusting the chlorine addition rate.
It is important to maintain the addition rate constant during the acryloyl chloride addition.
See also
Some microorganisms produce undesirable metabolites when fed at too high a medium addition rate.
The addition rate and process temperature is optimized for the initiator used.
A combination of control of liquid addition rate and liquid outlet rate may also be used.
The slow addition rate of the precursor emulsion insures lower polydiorganosiloxane droplet concentrations.
The reaction is controlled with a cooling bath and by carefully monitoring the addition rate.
The titrant addition rate will determine the mass deposition of crystals onto the tissue.
The tertiary-butyl chloride addition rate was linear.
The addition rate depends on the desired density of UV fibres in the finished paper.
Therefore, it becomes difficult to control the reaction if an addition rate is too fast.
The maximum addition rate was reached after 1 hour.
Once the inversion point was reached, the water addition rate was increased.
Initiator addition rate is adjusted so as to complete addition in about 4 hours.
Four sets of samples were produced at each addition rate ( of the surfactant system ).
The addition rate was controlled in order to have both containers empty after 90 min.
The reaction was maintained at gentle state by adjusting the addition rate ( exothemic ).
The feed addition rate was maintained at a constant level during the entire fed-batch phase.
Thanks to their developed structure, the percolation threshold is reached at a low addition rate.
The time-course changes of the addition rate of methanol are shown in Fig.
The exotherm is controlled by applying cooling and / or slowing down the addition rate.
The addition rate was adjusted so that the temperature of the reaction did not exceed 5°C.
Example 2 Change in measured value of the fucose addition rate of AFP by sialidase treatment.
The addition rate of the chlorosulfonic acid was adjusted to keep the reaction temperature below 0°C.
The method of claim 2, wherein the fed batch process uses an addition rate of,.
The addition rate was controlled so the internal temperature did not exceed 0 °C during the addition.
Since the reaction was exothermic, the temperature was maintained under 45°C by controlling the addition rate.
The unit of this addition rate is usually expressed in 1/min.
Addition rate between 2 % and 4 % appears to be reasonable without any overcharging effects.
The sulfur dioxide gas addition rate was 15 pounds per ton of dry kaolin.
Addition rate of this mixture was 0.3 mL / min for each liter of lysate.
Coating agent ( s ) ( kind and addition rate of coating agent ).
The acid addition rate during the reaction was about 1 liter / hr.
Ammonia was pumped through the oven at an addition rate of 0.020 gram per minute.
The nitrogen addition rate was 2.9 litres of nitrogen per kg of coffee solid.
The emulsifier solution addition rate is 142 L / h for all runs.
If the addition rate is greater than 3 mass %, the thermal shock resistance will deteriorate.
You'll also be interested in:
Examples of using Addition
Show more
Research will be in addition to your other duties
In addition it enables a graphic display of the results
Obtain total result of addition and subtraction
Examples of using Rate
Show more
The mortality rate is certainly on the rise
Rate stations and assign audit points
Low literacy rate and school attendance
