Examples of 'attach the cable' in a sentence
Meaning of "attach the cable"
attach the cable: To connect or secure a cable in its proper place or position
How to use "attach the cable" in a sentence
Basic
Advanced
attach the cable
Attach the cable with new straps.
We are gonna attach the cable to the jeep.
Attach the cable management arm.
Use cable clamps to attach the cable to the mast.
Attach the cable cover to the mounting plate.
Route the cable through the hole and attach the cable gasket to the hole.
Attach the cable ends to the rudder bellcrank.
Route the cable through the hole and attach the cable gland to the hole.
Attach the cable holder to the rear of the.
Used where necessary to attach the cable to the user 's clothing.
Attach the cable holders as shown in the illustration below.
For even better reception, attach the cable to a suitable house antenna.
Attach the cable to your clothing with the clip.
After you connect the cables, attach the cable cover to the mounting plate.
Attach the cable at the slice and adjust the length.
See also
Do it fast . We are gonna attach the cable to the jeep.
Attach the cable management cover to the back of the projector.
Use a tie wrap or cable clip to attach the cable to the PV racking, so.
Attach the cable from the outside antenna to the surge protector.
Forget the winch, we will attach the cable right to the Jeep.
Attach the cable connector to the serial port on the docking station.
Sapuli, help them attach the cable.
Attach the cable onto the cable clamp before starting the machine.
It 's Lisa . We managed to attach the cable to the top of the cage.
Attach the cable tension monitor to the wall using the hardware provided.
Forget the winch. We're gonna attach the cable to the jeep.
Attach the cable from the extra drum to the cable in the drain.
Direct-pull and calliper, Loosen the cableclamp bolt and attach the cable again.
We managed to attach the cable to the top of the cage.
Fit the cable fastener ( 6 ) in the indicated position and then attach the cable 7.
Attach the cable to the junction box by removing some of the sheathings first.
We will attach the cable to the Jeep.
Attach the cable with the cable clip located to the right of the terminal board.
RF connector to attach the cable for broadband internet access.
Attach the cable right to the Jeep.
Well attach the cable to the Jeep.
Attach the cable adapter with the two knurled screws to the GSM modem.
If possible, attach the cable to another computer that is working properly and print a document.
Attach the cable tension monitor Required.
You should attach the cable to a 10 Mb-Ethernet port on your DSL modem.
Attach the cable clamp provided with interface / connector cable to the thick.
To attach the Cable management cover.
Always attach the cable with a clip at your clothing or, even better, at your headband.
Just attach the cable to the mount next to the outer door, fill the BC.
Attach the cable to the network connector ( supports PoE class 2 ) in.
Attach the cable to the network connector ( supports PoE class 1 ) in the camera.
Attach the cable with the black cap ( 2 ) to the negative battery terminal.
Attach the cable and switch to the bracket see Figures 3 and 4.
Well attach the cable to the Jeep . - Yank them into the sun fast.
Attach the cable strain relief ( 5 ) on the lower handle hoop 7.
You'll also be interested in:
Examples of using Cable
Show more
Secure the coaxial cable to the ceiling
A cable tie is provided with the appliance
Use plenum rated cable where it is required
Examples of using Attach
Show more
Attach foot with right side pin
You will need to attach an external player
Attach foot with left side pin
