Examples of 'auxiliary fence' in a sentence
Meaning of "auxiliary fence"
This phrase refers to an additional or secondary fence that is used in conjunction with the main or primary fence. It serves as a complement to enhance security, prevent unauthorized access, or provide an extra barrier for safety purposes. The auxiliary fence is usually installed within the vicinity or alongside the primary fence
How to use "auxiliary fence" in a sentence
Basic
Advanced
auxiliary fence
Use the auxiliary fence and push block.
Place workpiece against the auxiliary fence extrusion.
Remove the auxiliary fence before making a bevel cut.
Holes are provided in the fence to attach an auxiliary fence.
To attach the auxiliary fence to the rip fence.
Mark the hole locations on the backside of the auxiliary fence board.
Place auxiliary fence wood against miter saw fence.
Check for interference between the auxiliary fence and lower blade guard.
Use auxiliary fence as instructed and shown in figures below.
The fence also has holes which are used to secure an auxiliary fence if desired.
Fasten the auxiliary fence using flat head screws.
Drill the marked hole locations all the way through the auxiliary fence.
Attach the auxiliary fence securely and make a full depth cut.
The Felder foldaway auxiliary fence.
The auxiliary fence must be removed for all bevel cuts blade tilted.
See also
How to make and attach an auxiliary fence for rip cutting thin workpiece.
The auxiliary fence can be taken off and reversed after loosening knob.
Always check for clearance between auxiliary fence and saw head before making cuts.
Attach auxiliary fence to rip fence for cuts that run the length of the stock.
If a bevel cut is desired, the auxiliary fence will have to be removed.
The auxiliary fence is used with the saw in the 0 bevel position.
Use the holes which are pre-drilled in the fence to attach an auxiliary fence.
Drill four pilot holes through auxiliary fence and run screws from rear of metal fence.
To prevent a long board from wobbling, fit the miter gauge with an auxiliary fence board.
Build auxiliary fence by following pattern below - Material.
Drill holes and temporarily mount this piece similar to building an Auxiliary Fence see page 21.
Push sticks, push blocks or auxiliary fence are types of “ work helpers ”.
Follow the diagram in Fig . 35 to construct the narrow rip auxiliary fence SS.
Attach the auxiliary fence to the rip fence with two “ C ” clamps.
Cut-off piece Stopped by Auxiliary fence.
This auxiliary fence is constructed of straight wood approximately 1/2 ” thick.
See figure 25 for auxiliary fence dimensions.
Place the square nuts ( 2 ) to the slot of the auxiliary fence 3.
Always make and use and auxiliary fence when ripping material 1/8 in . or thinner.
When you bevel cut ( blade tilted ), remove the auxiliary fence.
Attach the auxiliary fence to the mitre gauge with the washers ( 3 ) and screws 4.
Remove the saw 's sliding fences ( see page 29 ) before attaching the auxiliary fence.
Follow the diagram in Figure 35 to construct the narrow rip auxiliary fence A13.
You'll also be interested in:
Examples of using Fence
Show more
I want the fence and the baby
Fence the waste brine conditioning ponds
Be sure to use the fence for protection
Examples of using Auxiliary
Show more
Call in auxiliary cops if you have them
The incoming hole diameter on auxiliary terminal
Auxiliary contacts and failure signal units
