Examples of 'back box' in a sentence
Meaning of "back box"
a term commonly used in the automotive industry to refer to the rear portion of a vehicle, usually the trunk or cargo area
How to use "back box" in a sentence
Basic
Advanced
back box
Slide heater and back box out.
Attach the back box to the mounting surface.
Gauge steel cabinet and back box.
Installation of back box in new construction.
For surface mounting with back box.
Installation of back box in existing construction.
This heater is to be mounted only using back box.
Mount back box to wall using.
Make sure to install back box properly.
Back box must be securely mounted to the building structure.
Open the hinged door to the back box.
Determine which side of the back box is to be mounted against a.
Knockouts are provided throughout the alarm back box.
Power supply must enter back box through the knockouts.
Most are located in the back box.
See also
The back box may be adapted to be secured in place by fixing means.
Do not use the knockouts in right side back box.
Place the back box into wall opening flush with fin.
Position thermostat above slot in right end of back box.
Remove one knockout in the back box for entry of supply wiring.
Install the ceiling tile with the back box.
Pull wiring into the back box through the conduit fitting.
Bring power supply wiring cable to the back box.
Once back box is secured to the stud the spacer can be removed.
Install a cable clamp in the knockout in the top of back box.
Must be used with back box do not operate without front cover in place.
Connect wiring to the circuit board inside the back box.
Open the back box and create openings by pushing one or two holes.
The heater assembly must be installed in the back box provided.
Position the back box on the stud or joist location desired and secure.
Guide the flange through the slot openings in the back box.
Remove knockout in the top of the back box and install a cable clamp.
The fixing clips may be constructed integrally with the back box.
Place the back box into wall opening flush with finished wall surface on.
This will allow the frame assembly and back box to be fastened securely together.
Back box must be installed with front edge flush with the finished surface.
Allow for the thickness of the finished surface when installing the back box.
The edge of the back box must be installed flush with the finished surface.
The screws thread into holes located in the side flanges of the back box.
Follow the instructions with the back box for fitting and running the cable.
Apply the supplied gasket strip around the subwoofer hole in the back box.
Power supply must enter back box through the knockout behind the disconnect switch.
Do not ground the shield drain wire at sensor or inside alarm panel back box.
The back box must be installed with the front edge flush with the finished surface.
Connect a shielded twisted pair cable from the junction box to the back box assembly.
Fit the back box into the opening by sliding the supply wiring cable into position.
This allows enough space for the grille to fit properly over the back box flanges.
See also TOP marking on the back box for proper orientation.
It is many years It was not his back box.
Care must be taken to avoid the Back Box rattling against the wall.
You'll also be interested in:
Examples of using Box
Show more
Pull the box out as far as possible
You blind someone with that box
The box the vacuum cleaner came in
Examples of using Back
Show more
Looking to get back up on that pogo stick
I moaned at my father so much that he brought me back
But he went back and did it all the same
