Examples of 'battery cap' in a sentence
Meaning of "battery cap"
A battery cap is a removable cover or lid that provides access to the compartment where batteries are inserted or replaced in an electronic device or equipment. It ensures the secure placement and protection of the batteries, preventing them from falling out or being damaged. Battery caps come in various shapes and sizes, depending on the specific device they are designed for
How to use "battery cap" in a sentence
Basic
Advanced
battery cap
Check to ensure battery cap is fully engaged.
Battery cap not installed properly.
Be careful not to over tighten the battery cap.
Replace battery cap and tighten by turning clockwise.
Press the upper part of the battery cap to unlock it.
Battery cap for a watch case.
Replace the ignition battery cap after the battery.
The battery cap is split to make this task as easy as possible.
Do not force the battery cap when you close it.
This product should not be used without the battery cap installed.
Remove the battery cap at the top of the unit.
The water resistance rating applies only when the battery cap is installed.
Install the battery cap by turning it one quarter turn clockwise.
Do not attempt to use this product if the battery cap is not securely closed.
Use the battery cap tool to open the battery cover.
See also
Align the arrow in the cap with the square to remove the battery cap.
Do not remove the battery cap strip for any reason.
Make sure you and the light are dry before opening the waterproof battery cap.
Take off the protective battery cap before placing the.
Remove battery cap and insert AA battery with positive pole facing out.
Using coin or a wide blade screwdriver turn the battery cap counterclockwise one quarter turn.
Replace the battery cap on the back of the remote control.
Removing the Battery from the Tool Turn the battery cap counterclockwise to unlock.
A protective battery cap is supplied to cover the contacts of a detached battery pack.
The user should never attempt to remove the Battery Cap except for Battery recycle.
Remove the battery cap from the back of the remote control.
Then, cover the battery with the battery cap.
Replace the ignition battery cap after the battery has been install.
Typically, users use a coin to open the battery cap.
Replace the ignition battery cap after the battery has been installed.
To install the battery, use a coin to open and close the battery cap.
Pull the plastic battery cap away from the hub using the molded handle.
To change the light mode setting, remove the battery cap and holder.
Keep the Battery Cap and unit clean to assure a good seal.
In other words, less than the battery cap of a large flashlight.
Remove battery cap and reinstall, making sure it can be fully engaged.
When transporting, make sure the provided battery cap is attached to the battery.
To remove the Battery Cap will destroy the operation of the unit.
If at any time you suspect the vent opening is clogged, replace the battery cap.
Screw on battery cap hand tighten - do not use tools.
If at any time you suspect the vent openings are clogged, replace the battery cap.
Remove battery cap from top of the fuselage see step 4 diagram.
Caution, Do not overtighten the battery cap.
To install, remove the battery cap located on the side of the device.
Said expansion therefore takes place against the rigid battery cap 37.
A protective battery cap ( q ) is supplied to cover the contacts of a detached battery pack.
Insert battery negative end first ( flat end ) and close battery cap.
A protective battery cap ( p ) is supplied to cover the contacts of a detached battery pack.
Make sure that the positive ( + ) pole of the battery is facing the battery cap.
A protective battery cap ( j ) is supplied to cover the contacts of a detached battery pack.
You'll also be interested in:
Examples of using Battery
Show more
The battery icon flashes during charging
Danger of explosion if the battery is incorrectly replaced
The battery pack is probably completely empty
Examples of using Cap
Show more
Retighten the cap to the filter housing
Cap and back panel sheet steel
Do not install cap onto water bottle
