Examples of 'belt speed' in a sentence
Meaning of "belt speed"
{'a': 'belt speed - This phrase typically refers to the rate at which a conveyor belt or other moving mechanism transports objects or materials. It is a measure of how fast the belt moves in relation to the items being conveyed, and it is often used in industries such as manufacturing, logistics, or mining to optimize efficiency and productivity.'}]
How to use "belt speed" in a sentence
Basic
Advanced
belt speed
Belt speed control electronic models only.
Continuously variable belt speed via variator.
The belt speed is related to heat budget.
Load or flowrate control by belt speed.
Thumbwheel for belt speed preselection.
The belt speed of the conveyor belt is variable.
Refer to the procedure for determining belt speed below.
The belt speed determines the cooking time.
Calculate the belt speed.
The highest belt speed possible is a measure of reactivity.
Exposure was controlled by controlling the number of passes at a constant belt speed.
Other belt speed on request.
Generally the magnetic field strength is proportional to the belt speed.
Adapt the belt speed or belt tension in case of occurring vibration.
These samples were made on table washers where the belt speed was very slow.
See also
Lowering the belt speed reduces the capacity of the process.
The panel can be several meters wide and the belt speed is high.
Belt speed increasing.
Both air temperature and belt speed are in any case adjustable.
Belt speed maximum.
The assemblies and collection belt speed may be adjusted by a suitable computer control.
The control system may also adjust a belt tension in response to belt speed.
The belt speed is applied to scanning device vÃa the encoder output.
The drive pulley is generally traveling at a greater speed than the belt speed.
The final belt speed is then calculated using the following formula.
The control electronics permits the infi nitely variable adaptation of the belt speed.
The belt speed may be calculated using one of the following formulas.
This is because the opening of the distributor depends on the discharge conveyor belt speed.
The grasping belt speed is set to match the predetermined line speed.
HRC SPEED heart rate control is based on automatically changing belt speed.
The optimum belt speed depends on the workpiece and the workpiece material.
Increasing the distance R increases the belt speed for a given pulley shaft RPM.
The abrasive belt speed depends upon the desired cut rate and surface finish.
Decreasing distance R decreases the belt speed for a given pulley shaft RPM.
Set the belt speed control to the correct speed for the job electronic models only.
The higher the number, the higher the belt speed.
The higher this belt speed the more reactive the photoinitiator tested.
Additionally, drying belt width and belt speed can be modified.
The necessary belt speed can be preselected with the thumbwheel 4, even during operation.
During such transitory periods, increase or reduce the belt speed as appropriate.
CFS regulates the belt speed and sends a signal to the.
Switch on the device by turning the button 1 and setting the small belt speed.
After 5 minutes approximately, reset the belt speed selector to its original position.
The belt speed of the conveyor 31 is subsequently reduced gradually from the situation in fig.
What must the reflow oven belt speed be to accommodate this cycle time?
The belt speed of the conveyor belt 22 herein remains constant.
Flow regulator setting determines conveyor belt speed and consequently, density of spreading material.
Curing of the clearcoats at a predetermined curing rate at a belt speed of 30 m / min.
Again, this belt speed depends upon the desired cut rate and surface finish.
Preferably, both the air temperature and the belt speed of the cooling section are adjustable.
You'll also be interested in:
Examples of using Belt
Show more
I am wearing a belt of staples that go into my skin
I think there are actually whales on his belt
He had a belt tied around his neck
Examples of using Speed
Show more
The speed of the vacuum source shall be
I must have hit speed dial by mistake
Zoom speed is determined by the amount of rotation
