Examples of 'bent part' in a sentence
Meaning of "bent part"
bent part: Describes a component or section that is visibly curved, deformed, or twisted out of its original shape or position
How to use "bent part" in a sentence
Basic
Advanced
bent part
This bent part is called the trigger.
In the form of a stamped and bent part.
Bent part of the base plate of shear blades.
The piece of dromedary droppings is fixed near this bent part.
Bent part of the fixing leg is not grounded.
The groove may be formed by a bent part on the web portion.
Bent part of the base plate of.
Make sure that the only bent part of you is your knees.
The bent part preferably lies against the upright edge.
It should be understood that the bent part may be implemented in various forms.
However, a large curvature radius can increase the size of the bent part.
The shape of the bent part is an arc or a curve with a continuously changing curvature.
The different legs are parallel to one another with a bent part to have a connection.
Preferably, the bent part is attached to the second cover.
The leading end is provided with a short and sharp bent part directed downwards.
See also
Further, the bent part may be attached to the second cover.
This implies that the length of the bent part is such that,.
That bent part is no longer covered with a three-layer end winding corona protection.
Install the vibration-proof rubber so that bent part of the fixing leg is grounded.
In addition, the heat transfer pipe generally has a linear part and a bent part.
Shower drain as claimed in claim 4, wherein the bent part lies against the upright edge.
The central bent part 321 is formed of an elastically deformable material.
Antivibratory spacers 7 further hold tubes 3 in position in their bent part.
Behind that bent part 8, the winding is inserted in a slot section 9.
The winding as shown on Fig 2 also has a bent part 8.
Another bent part 10 is found on the other side of the end winding.
Plating adhesion, Evaluated from state of plating peeling of bent part in 60°V bending test.
The central bent part 321 has a shape that partially protrudes downward.
On the side facing the spring 11, the lock 9 has an upwardly bent part.
The presence of the bent part 41 facilitates manipulation and the putting into place of tongue 38.
Furthermore, the gun 1 comprises a body 2 having a bent part 2 a on which a nozzle 36 is snapped.
A short rectangular bent part 40c is the same color as that of the adjacent semicircular part 33c.
The minimum distance is the distance between the bent part 285 and the stator core 61.
B, A bent part is whitened, but returns to its original shape ( a restitution ability exists ).
Also provided here on upright edge 22 is a bent part 26 between which a flexible sheet 27 is clamped.
Further, bent part 10 is not limited to a single one at the final shaped article 1.
For smaller diameters face the bent part of the saddle plate (part No. 3) inwards.
In the bent part a lid 21 can be seen also.
After that, the bent part of the vent is pressed ( rolled ).
The downwardly bent part 54 is formed with a lower fastening hole 55, which is a threaded hole.
Such clamping keeps bent part 34 of the spring in hollow 51 where it is engaged.
