Examples of 'bit is set' in a sentence
Meaning of "bit is set"
bit is set: This phrase may refer to a certain situation, condition, or context being established or defined
How to use "bit is set" in a sentence
Basic
Advanced
bit is set
The bit is set for a one third rotation.
This single bit is set to one.
The bit is set if the page has been referenced.
Each task is executed in order as long as its calling bit is set.
This bit is set to zero on reset.
This function returns whether the interlace bit is set for the image.
The k th bit is set to zero.
Remaining fields are required when the RA bit is set.
This bit is set.
Status reports are triggered when a PDU is received in which a poll bit is set.
This bit is set if the consistency check of two consecutive IRIGtelegrams fails.
They are only present when the corresponding bit is set in the options field.
The cheater bit is set to one because the viewer is attempting to cheat.
Remain low until the CKP bit is set and all other.
The bit is set to zero for the last message fragment sent.
See also
In the FIFO mode this bit is set.
If the busy bit is set then the control store load was not successfully completed.
The corresponding MODE bit is set to zero.
This bit is set if the SSTP packet is a control packet.
The associated Error Code bit is set for any detected error.
This bit is set to 0 for control messages.
When disconnection is desired the value of the bit is set to 0.
A Grant Enable bit is set to one whenever a grant is issued to a user.
If these states are different, then the output bit is set as indicated above.
This bit is set to zero by reset on power-on.
Explain how to test whether the high-order bit is set in a byte.
If the bit is set then no read / write error was encountered.
Tell me how to test whether the high-order bit is set in a byte.
The first bit is set to 1 if the point is above the viewport.
This field may also contain asynchronous error codes, when the data invalid bit is set.
This bit is set to 1 when there are more fragments belonging to the same frame.
Otherwise, the bit is set to zero.
When a bit is set to 1, it means that the OSU provider provides the corresponding service.
In this example, the from-AP bit is set to zero.
When this bit is set to one, the SPI subsystem is enabled.
The mixed mode bit is set to 1.
If this bit is set to 1, the current frame will not be.
By default the bit is set to 1.
This bit is set to 1 if the.
Sets bit index in a . set clear defines if the bit is set to 0 or 1.
For example, the marker bit is set only for the last packet of each step.
When information is inserted into an empty slot, the busy bit is set to 1.
In the first way, a bit is set in a particular HTC field.
After the execution of the first scan, the " first scan " bit is set.
The framing bit is set to 0 in the following cases,.
G file True if file exists and its set-group-id bit is set.
When the current bit is set to 0, output terminal is positive.
In other words, the BS determines whether the mode switch indication bit is set to ' 1 '.
The locking bit is set equal to 0 in the following cases,.
Used when virtual addressing is enabled, hence when the PG bit is set in CR0.
You'll also be interested in:
Examples of using Bit
Show more
A little bit over my head right now
At least the baby puts up a bit of a fight
I was in a bit of a jam and he came through for me
Examples of using Set
Show more
These targets are set as cumulative national goals
Set days and time of regeneration or recharge
The units may be set to different channels
