Examples of 'blocking time' in a sentence
Meaning of "blocking time"
blocking time: Refers to the practice of allocating specific time periods for particular tasks or activities, often used in scheduling or time management
How to use "blocking time" in a sentence
Basic
Advanced
blocking time
The blocking time is independent of the concentration.
With respect to the blocking time.
The blocking time is evaluated visually.
Increasing the force increases the blocking time.
The blocking time was visually evaluated.
Table for the new blocking time for saber.
Its blocking time has to be shorter than measured lifetime.
A single mutation has a drastic effect on the blocking time.
Blocking time gets you started and maintains motivation.
This first method may be used for calculating an optimum blocking time.
The blocking time depends on temperature and buffer conditions.
The quality of hybridization is measured by the mean value of the blocking time.
The blocking time for compressor has not yet elapsed.
A double mismatch reduces the blocking time so much that it can not be measured.
Blocking time on our calendars encourages us to work on a specific task at a time.
See also
Conclusion of the Commission on the matter of the blocking time.
The proposed new blocking time was tested at three FIE competitions.
The error can only be reset after a blocking time of 1 s.
The blocking time increases using RNA or INA oligonucleotides.
A change of the applicability or the inapplicability of the blocking time information and / or.
A change of the blocking time information and / or.
The compressor switches itself on automatically after the 20 minute blocking time has elapsed.
Thus, the blocking time has been effectively halved.
There is thus obtained for the provisional blocking time t + the following relation,.
Histogram of the blocking time displays a Poisson distribution with a 2 seconds mean value.
In this case, the error can be reset only after the blocking time has elapsed.
Therefore, the blocking time of the track is very low.
Converting three bases from DNA to INA increases the blocking time by a factor 5.
Fixed blocking time of 1 s, no driver setups.
One INA replacing DNA increases the blocking time by more than 2 times.
The blocking time at level %1 should be lower than the expiration time.
Certain errors ( e . g. earth fault or short circuit of the motor phases ) may cause a blocking time.
Typically the blocking time decreases by a factor 3 when temperature increases by 10 degrees . FIG.
As seen on Fig . 5a, increasing the temperature significantly reduces the blocking time.
In Fig . 4 the blocking time versus force for the different oligos is shown.
Adding gp43 DNA polymerase without NTP increase the blocking time of oligo-nucleotides.
The minimum blocking time is 10 minutes.
The gp43 polymerase increase the blocking time of an oligo by a factor 10.
The " Error codes " table gives the blocking time ( if available ) for each error.
You'll also be interested in:
Examples of using Time
Show more
Spent a lot of time with the ladies
Time and tide wait for no man
A woman needs time to think things over
Examples of using Blocking
Show more
The floating switch is blocking in automatic operation
Blocking direct sunlight during cooling opera
The silt is blocking their port hatch
