Examples of 'bolts should' in a sentence
Meaning of "bolts should"
bolts should ~ suggests that bolts need to be properly tightened or secured to ensure safety or proper functioning
How to use "bolts should" in a sentence
Basic
Advanced
bolts should
Transport bolts should be installed prior to moving.
Retaining nuts and packing bolts should be tight.
Securing bolts should be firmly tightened.
He thinks all public buildings that use these bolts should get additional nuts.
All bolts should be inserted from the top.
The length of the bolts should be appropriate.
The bolts should be tightened to the following torques.
The tightening of cylinder head bolts should be carried out by a specialist.
Lock bolts should recede into the unlocked position.
At this point, all bolts should be tightened.
Lock bolts should extend into the locked position.
For the installation 4 metric M6 bolts should be used.
The bolts should straddle the front hitch tube bolt.
For safety reasons wheel bolts should be protected by special caps.
Bolts should occupy the outermost available holes in the axle plate.
See also
The compressor head bolts should be kept properly torqued.
Bolts should be extracted and inspected as part of regular fire escape inspection.
So, if I'm understanding this correctly, this is how the bolts should be:.
Latches and bolts should be centered with their respective strikes.
Replacement M12x35 bolts are provided with each castor, the removed bolts should be.
These bolts should be the diameter of the holes in your saw base.
The tightening torque of the brass nuts on brass bolts should be - > 2 Nm for M 5.
Checking your keel bolts should be part of your annual maintenance plan.
The bolts should go through the corner openings and through the casing.
After installation, all bolts should be carefully screwed up for a second time.
Backrest bolts should be tightened to a snug position while still allowing free backrest movement.
Note, All bolts should be inserted from the top.
The bolts should be installed with their heads outside, remembering about the plastic washer.
Type of the Bolts should be chosen appropriately to the type of the wall.
The bolts should be snug, but NOT over tightened as this is a pivot area.
Mounting bolts should be installed with the bolt head at inside surface of the transom.
The mounting bolts should not be more than 2 mm smaller than the intended mounting holes.
Bolts should not be worn and / or bent.
Bolts should be tightened using appropriate tightening torque according to TABLE 5.3.
You'll also be interested in:
Examples of using Bolts
Show more
Heads of bolts go on the inside of the cart
Fasten with the previously removed bolts
Push bolts into holes on back of handle
