Examples of 'butt joints' in a sentence
Meaning of "butt joints"
Butt joints: These are joints in woodworking or metalworking where two materials are joined at their ends without any overlapping. Butt joints are often used in construction and carpentry
Show more definitions
- plural of butt joint
How to use "butt joints" in a sentence
Basic
Advanced
butt joints
The vertical butt joints are not visible.
Tape should overlap tape applied to butt joints.
In case of butt joints these have to be cut before the seams.
Reinforced butt joints.
Using tenoned butt joints is an effective method for constructing a cabinet carcase.
These welders must be capable of making butt joints of high quality.
Properly made butt joints are as strong as areas of the pipe without joints.
It is used with lower current levels for welding lap or butt joints.
Carcase butt joints.
Roof coverings are normally formed using sheets of zinc with butt joints.
Frame butt joints.
The butt joints of adjoining plies are preferably staggered to prevent introducing points of weakness.
This airplane had a metal fuselage with butt joints of which we were very proud.
Reinforced butt joints may require additional steps which are detailed below.
This enables fast construction and minimizes the butt joints between the boards.
See also
Horizontal edge joints and butt joints on opposite sides of the studs were not staggered.
Butt joints on the other hand yield much higher percentages of base metal melting.
This approach can be used to create butt joints and lap joints with complete penetration.
In particular, a high strength structure can be obtained by the circumferentially offset butt joints.
Processing Panel butt joints / Fill as joint filler.
To support the Transition-Molding, Install furring or strapping where butt joints are located.
These layers include butt joints which are offset from each other by 90 °.
The corners of the box-section sub frame are butt joints which are welded.
Four offset butt joints 9 are shown on the left and right side, respectively.
The piping connections were installed using direct braising methods and simple butt joints Figure 5.
Joints include all types of joints, e.g. butt joints and tongue and groove joints.
Everything was cut at 90 degrees to make simple butt joints.
Thus, the butt joints 9 must be sufficiently offset to allow the inter-layer force transfer.
A metallic foil tape 15 is then applied over the butt joints.
For example, butt joints are divided into 32 species.
Figure 51 is a fragmentary pictorial sectional view of a device for fairing butt joints of adjacent subassemblies ;.
The butt joints of this form are offset from each other by 120 °.
Interfacing appliqués 10 usually are overlapped ¼ to ½ inch or more, but butt joints are possible.
Fig . 8 is an enlarged view of some of the butt joints illustrated in Fig . 7.
You'll also be interested in:
Examples of using Joints
Show more
We smoke a couple joints and forget everything
Joints shall be well aligned and adjusted
Elimination of deck joints and deck drains
Examples of using Butt
Show more
Somebody to kick butt and take names
Your butt looks cute in those pants
Now sit your butt back down
