Examples of 'calibration value' in a sentence
Meaning of "calibration value"
Refers to a numerical or measurement value used to adjust or set the precision or accuracy of a device or instrument
How to use "calibration value" in a sentence
Basic
Advanced
calibration value
The corresponding calibration value is automatically highlighted.
Display shows next required calibration value.
Indication of calibration value of the control system.
Display shows indication of necessary calibration value.
One example calibration value is a power calibration value.
Calculate the low point calibration value by.
This second calibration value is specific to each power meter.
Multiply the number of intervals by the calibration value.
A calibration value can be calculated for each calibration sample.
Perform calibration from lower to higher calibration value.
Calibration value is saved.
The figure shown in brackets is the measured calibration value.
The order in which the calibration value and measurement value are obtained is unimportant.
For information about the barometric pressure calibration value.
This calibration value is then applied to a corresponding adjustment device in the integrated circuit.
See also
Hence appreciable errors in the calibration value have been made.
You may see a brief delay in screen display immediately after entering a CGM calibration value.
The initial deformation for obtaining a given calibration value will be determined empirically.
This is permanently powered by the battery so as to maintain the calibration value.
This value is the zero calibration value and should be recorded in the table below.
This card records individual information such as a calibration value.
This initial travel time Ti corresponds to a calibration value determined for a given type of electromagnet.
The pressure level in the system will gradually return to the set calibration value.
The calibration value can be written over XML.
The calibration cylinder matches the expected calibration value expected in the instrument.
The correct calibration value is thendeleted in stand-by mode.
The meter arrangement and the timer will then have a calibration value for the fixed volume.
Once the calibration value is set, do not toggle out of the dB mode.
Percentage error of the calculated Mp and the calibration value.
Signal not in range - calibration value very different from last calibration value.
Temperature measuring instrument with reference temperature sensor Read out the calibration value here.
If needed, the factory default calibration value can be recovered.
Thus, the same calibration value is applicable to the different reference current sources.
If the temperature reading is inaccurate, enter a calibration value in the corresponding section.
The assembly of claim 9, wherein calibration data includes a factory determined calibration value.
This value is used as a calibration value and is stored in the signal-processing unit.
In one embodiment, the same parameter is used for each calibration value.
The calibration value is then stored as a pulse-width modulation waveform in the shift register.
This variant will then yield the wet calibration value LiW *.
The calibration value increases and decreases in units of 1 Hz.
Thus the user-site relative characteristic is referenced to the dry calibration value.
Pressing the button for 3 seconds the calibration value is stored and the procedure is ended.
Take a water sample and measure the conductivity with an accurate conductivity meter, calibration value.
Set the required calibration value as described in " Adjusting temperature setpoint " example.
This " range " represents the measurement detection range from which a standard calibration value can be obtained.
The calibration value ( digits ) saved last will be indicated.
Single-point-calibration, a luminescence measurement value of the dry sensor is obtained and taken as a calibration value.
The expected calibration value ( µs ) is marked on the calibration rod.
The nut 26 is tightened with the spanner until the initial calibration value Vo is reached.
A calibration value of " 1 " indicates that zone could not be calibrated.
You'll also be interested in:
Examples of using Value
Show more
Adjustments of value are recognized in the income statement
Promoting and reinforcing local value systems
Farms and market value of agricultural products
Examples of using Calibration
Show more
Most resent calibration of the climatic cabinet
Generate an audit record except in calibration mode
Most recent calibration of the calibration lamp
