Examples of 'characteristic impedance' in a sentence
Meaning of "characteristic impedance"
characteristic impedance ~ a term used in electrical engineering to describe the impedance or opposition to the flow of electrical current in a transmission line. It represents the ratio of the voltage to the current in a steady-state sinusoidal wave
How to use "characteristic impedance" in a sentence
Basic
Advanced
characteristic impedance
Terminating the line in its characteristic impedance.
Low characteristic impedance lines require a wide line.
Maintain the same characteristic impedance.
The characteristic impedance of the line.
This includes abrupt changes in the characteristic impedance.
The characteristic impedance of the coupler depends on the final installer.
This variation enables adjustment of the characteristic impedance.
Characteristic impedance is unknown and not controlled along the power lines.
Each type of transmission line has a specific characteristic impedance.
This dispersion of characteristic impedance is the main cause of the limitations of this approach.
The lines preferably have the same characteristic impedance.
The same calculation of characteristic impedance is carried out for other pillar diameters.
The performance of a transmission line is governed by the characteristic impedance of the cable.
One example is that the characteristic impedance will decrease with decreased wood moisture.
This means that there is not an entirely free choice of characteristic impedance.
See also
Calculation of characteristic impedance.
A current value on a distributed constant line is inversely proportional to the characteristic impedance.
It should be noted that the characteristic impedance varies with frequency.
Stubs can be used to match a load impedance to the transmission line characteristic impedance.
One of the most important is the characteristic impedance of the transmisslon line.
The line width depends on the directivity and on the desired characteristic impedance.
Characteristic impedance of other geometries and offsets follow by theory similar to those described below.
This results in a step change in the characteristic impedance of the waveguide.
The characteristic impedance of the network may be determined using known characteristics of the network.
Antipodal finline is used where very low characteristic impedance is required.
The characteristic impedance of this cable is Zc.
This resistance value is called the characteristic impedance of the line.
The characteristic impedance for a rectangular outer conductor see Fig.
The cable used must have the same characteristic impedance as the component.
C Characteristic impedance of the guide.
The resistance of the resistor is then close to the characteristic impedance of said tube.
The characteristic impedance of a transmission line is determined by,.
A resonant line has a finite length and is not terminated in its characteristic impedance.
The SI unit of characteristic impedance is the ohm.
Design is particularly facilitated by providing all slugs with the same characteristic impedance.
The lines I are closed via their characteristic impedance ZO at the two extremities.
The characteristic impedance of each of said circuits ;.
The offset distances the two strips and consequently increases the characteristic impedance of the line.
The characteristic impedance of a coaxial line,.
The cable is used in a matched transmission line of characteristic impedance Zo.
Calculation of the characteristic impedance for various diameters of pillar ;.
The curves correspond to different values of the characteristic impedance Zm of the line.
However, the characteristic impedance of a network changes unpredictably over time.
For a line of real transmission, the characteristic impedance is a complex number,.
The characteristic impedance is then used to determine the ramp-down profile.
Zc corresponds to the characteristic impedance of the cable ;.
Each of these subsections is designed to have ( different ) required characteristic impedance.
It must be such that the characteristic impedance of this access point is 50 ohms.
Their performances are compared until 1 THz based on the same characteristic impedance.
Causing the values of characteristic impedance of the two resonant circuits to vary ;.
You'll also be interested in:
Examples of using Impedance
Show more
Speaker impedance ratings are less than precise
You can set the speaker impedance
Check the impedance of the connected speakers
Examples of using Characteristic
Show more
Another characteristic are the riveted hinge supports
Please describe the characteristic you love
Characteristic venation of tsetse wing hatchet cell
