Examples of 'conductivity of the water' in a sentence
Meaning of "conductivity of the water"
conductivity of the water: This phrase refers to the ability of water to conduct electricity. It is a measure of the water's capacity to transmit an electrical current, which is influenced by the presence of ions and dissolved substances in the water
How to use "conductivity of the water" in a sentence
Basic
Advanced
conductivity of the water
Electrical conductivity of the water is relatively high.
Salt can be added to increase the conductivity of the water.
The conductivity of the water increases.
The water may also be described by the conductivity of the water itself.
The conductivity of the water is monitored as a function of time.
The hardness values are based on measurements of the electrical conductivity of the water.
During flush the conductivity of the water is controlled.
Conductivity of the water.
In order to increase the conductivity of the water NaCl solution was added.
This indicates that the system was effective in consistently lowering conductivity of the water.
The relative conductivity of the water is measured over time.
An EC meter measures the electrical conductivity of the water.
The conductivity of the water is proportional to the total dissolved solids.
This meter measures and checks the conductivity of the water in the circulation tank.
The conductivity of the water reservoir is monitored online during the measurement.
See also
This meter measures and checks the conductivity of the water inside the circulation tank.
The conductivity of the water is measured continuously until the conductivity stops increasing.
If a water-soluble electrolyte is added, the conductivity of the water rises considerably.
The conductivity of the water must lie within the limits as set by the manufacturer.
Today, the salinity is usually determined by measuring the conductivity of the water.
The slightly higher conductivity of the water is due to the higher dissolved oxygen content.
After passing the reverse osmosis device 5, the conductivity of the water is about 1-5 µS / cm.
The conductivity of the water is measured by Metrohm rancimat and registered.
The process was repeated until the conductivity of the water removed was less than 90 µmho / cm.
The conductivity of the water should then be less than 1 micromho per centimetre.
Step " Pre Flush ” During “ Pre Flush ” the conductivity of the water is monitored.
The initial conductivity of the water decreased from approximately 20 µMhos / cm to below 2 µMhos / cm.
Repeat this process until the conductivity of the water removed is less than 90 µmho / cm.
The electrical conductivity of the water should not exceed 2 ds / m.
This resulted in a change of conductivity of the water exiting the filter, see Fig . 5.
Detect the conductivity of the water body ;.
Detecting the conductivity of the water body ;.
Repeat this process until the conductivity of the water removed is less than 90 microohm / cm.
You'll also be interested in:
Examples of using Conductivity
Show more
Note the conductivity registered by the controller
Continuously measures the conductivity of the effluent
Poor conductivity and slow to absorb heat
Examples of using Water
Show more
There is no water damage or fire extinguisher residue
Do not clean the engine with water
Water freezing in the system will break it
