Examples of 'conicity' in a sentence
Meaning of "conicity"
Conicity: The state or quality of being cone-shaped or tapering towards a point, often used in geometry or engineering
Show more definitions
- The quality of being conic.
How to use "conicity" in a sentence
Basic
Advanced
conicity
Conicity is a parameter based on lateral force behavior.
Existence of in service limits for equivalent conicity.
No conicity when working with large thicknesses.
Track test conditions for equivalent conicity.
Equivalent conicity design limit values.
Assessment of design values for equivalent conicity.
Conicity is an important parameter in production testing.
Requirements for controlling equivalent conicity in service.
The conicity offers a double advantage.
Rail head profile for modelling equivalent conicity.
Certain degrees of conicity have been found particularly advantageous.
Design values for equivalent conicity.
Alternative conicity grind routine with shoulder grinders.
The tubular element is in effect given a determined conicity.
No assessment of equivalent conicity is required for switches and crossings.
See also
This arrangement is usually termed the conicity principle.
The equivalent conicity that the unit was tested for.
This is similar to providing an effective conicity.
Requirements concerning equivalent conicity values which should be respected.
These bellows may be rounded with or without conicity.
Track test conditions for equivalent conicity representative of the network.
In service values of equivalent conicity.
Equivalent conicity in service.
This measurement is important to good tire performance in regards to conicity.
Such oscillations are inherent in the conicity principle wheelset.
Preferably these surfaces are provided with the corresponding conicity.
The conicity index was calculated according to the formula proposed by valdez.
Definition of equivalent conicity.
This conicity is also determined so as to ensure good removal of the material chips.
Simulated track test conditions for in service values of equivalent conicity.
Requirements for controlling equivalent conicity in service are an open point.
The alternative conicity grind routine is based on the following three concepts.
Assessment of equivalent conicity.
The target conicity value is dependent on the tire type or tire code.
It is possible to give the crucible a slight conicity in order to facilitate this operation.
Top and bottom grinders can be controlled independently to reduce conicity values.
The conicity or tapering of the openings can be provided by the connecting parts itself.
The second setting is the specific range or target value of conicity desired.
A very slight difference in the conicity of the winding can be observed during its enlargement.
The rails generally slant inwards at the same rate as the wheel conicity.
The following characteristics relate to the equivalent conicity defined by the infrastructure subsystem.
Nothing is said about an effect of improving the centering obtained by a relatively low conicity.
Tire designers have long sought to reduce or control conicity levels in radial passenger tires.
Equivalent conicity in service limit values for the track for the purpose of joint investigation.
Other designers have created reinforcement belts directed to tire performance parameters other than conicity.
Equivalent conicity is not relevant for trains equipped with axles whose wheels rotate independently.
These considerations will permit determining from case to case the conicity B which is advantageous.
The computer software activates the conicity grind routine based on the cycle configuration selected.
The conicity grind routine is operated with the tire turning in the CCW direction.
Track test conditions for equivalent conicity representative of the Finnish TEN network.
