Examples of 'connect the wire' in a sentence
Meaning of "connect the wire"
Connect the wire is a directive commonly used in technical settings to instruct someone to establish an electrical connection by linking one wire to another
How to use "connect the wire" in a sentence
Basic
Advanced
connect the wire
Connect the wire securely to the terminal.
Place the spark plug and connect the wire.
Connect the wire to the spark plug.
Turn off the power and properly connect the wire.
Connect the wire harness to the calibration unit.
The metal skeleton of the case is a good place to connect the wire.
Connect the wire aerial to the device and.
When reassembling it, be sure to connect the wire harness.
Connect the wire to the speaker.
Install a new lamp, then connect the wire again.
Connect the wire to the subwoofer.
Therefore, the space used to connect the wire to the connector is narrowed.
Connect the wire to the transmitter.
Three-pin connector to which to connect the wire of the cooling unit pressure switch.
Connect the wire to the earth screw on the amplifier.
See also
Fixed Starter, according to the method above to connect the wire.
Connect the wire supplied to the two wires on the humidifier.
Here's the powder. It goes in here. Connect the wire to the transmitter.
Connect the wire coming from the camera station to the.
For VHF reception ( FM ) you must connect the wire antenna to the micro system.
Connect the wire leads to the screw terminals on themicrophone circuit board.
Terminal board connections 1 Connect the wire from the 30V transformer " secondary 2 " to this.
Connect the wire leads to the screw terminals on the microphone circuit board.
See? If you don't hold it, I won't be able to connect the wire.
Now connect the wire hooks to the outermost hole in the horns.
It goes in here . Connect the wire to the transmitter . Switch it on.
Connect the wire to the red and white terminals on the garage door opener.
You can connect the wire to any of the negative battery terminals.
Connect the wire coming from the top to the wire coming out of the frame.
DO NOT connect the wire to the circuit panel at this time.
Connect the wire from the solar panel into the socket located under the light fixture.
Disconnect the wire from the spark plug and connect the wire onto the retaining post.
Connect the wire to some sort of complex mechanism in another room where Koko is.
Connect the wire terminals to the spill switch and re-secure the bracket.
To connect the wire feeder to the power source, complete the following steps.
Connect the wire with connector ( U ) on one of the two poles of the thermal switch.
Connect the wire to the right hand ( black ) terminal.
Connect the wire 1 of the roadside panel on the terminal 8 of the handset.
Connect the wire feeder IF 45 to the power source.
Connect the wire to the camera station see “ Wiring ”.
Connect the wire from the monitor station to the PCB see “ Wiring ”.
Connect the wire with white stripes to the ( + ) terminal.
Connect the wire feeder work lead / voltage pick-up cable clip ( 3 ) to the work piece.
Connect the wire from the 0V transformer " secondary 2 " to this.
Connect the wire ends into the “ SETBACK ” terminals ( 5 and 6 ) and tighten the screws no polarity.
Connect the wire ends into the “ RELIN ” terminals ( 2 and 5 ) and tighten the screws observe polarity.
Connect the wire " B " as follows using twist-on connectors " C " sized to connect direct wire to.
You'll also be interested in:
Examples of using Connect
Show more
Connect the adapter into a main socket
I feel the need to connect with someone
Connect stereo headphones or powered external speakers
Examples of using Wire
Show more
Steel wire liners can be coated or noncoated
Use a passage aid wire or previous cord
Cut wire liner at the right length
