Examples of 'connectors should' in a sentence
Meaning of "connectors should"
Connectors should refer to devices used to connect or join different components together. In the context of electronics or computer hardware, connectors are used to establish a physical and electrical connection between two or more devices or circuits. They come in various types such as USB connectors, HDMI connectors, or audio connectors
How to use "connectors should" in a sentence
Basic
Advanced
connectors should
Only new or clean connectors should be used.
All connectors should be of screw or locking types as far as possible.
The fatigue resistance of stud shear connectors should be determired.
Flues and connectors should not be galvanized.
Wire insulation should be intact and contacts and connectors should be secure and clean.
The cable connectors should be fully inserted into.
The side entry positions for these connectors should therefore be used.
Barb type connectors should always be double clamped.
Anyhow standard Eth cable with standard Eth connectors should work as well.
Unions or flexible connectors should be installed to facilitate removal of.
For production and cost reasons, the number of electrical connectors should be limited.
The hard drive connectors should face the back.
Connectors should be easy to handle, flexible and provide maximum performance at sea as well.
The collars of the speaker connectors should be screwed in all the way clockwise.
FC connectors should not be used in vibrating environments due to its threaded lock.
See also
The side entry positions for these connectors should therefore be used with European models.
Quick connectors should be used for connection to the compressed air source.
In this case, sealed connectors should be used.
Damaged connectors should be repaired promptly to avoid affecting the site operation.
If necessary, the spacing of the connectors should be adjusted accordingly.
The battery connectors should line up with the connectors inside the battery compartment.
Your computer 's video connectors should be,.
Cables and connectors should be checked on a regular basis for damage.
The colors of the indicators on the both ISOFIX connectors should be completely green . Fig . 14.1.
BNC connectors should be capped with the original protective covers.
The cable with RJ connectors should be interlaced.
The connectors should also be available of pre-determined diameter and length.
Suitably polarised high-current connectors should be used to avoid misconnection.
These connectors should extend from the side of unit 1 similar to the connector 3 of figure 1.
The top & bottom entry positions for these connectors should therefore be used with European models.
Hence, the connectors should be displayed when the wrapper is removed from the stack.
Typical insertion loss in PC, UPC and APC connectors should be less than 0.3dB.
However, all connectors should have one output and at least one input.
All cables and connectors should have good insulation.
At least one of the connectors should preferably be elastically deformable.
Pneumatic quick connectors should not be used near fire sources.
Open or improperly secured connectors should be secured in accordance with the producers recommendations.
When not in use the accessory connectors should be fitted with the protective covers supplied.
The battery posts and connectors should be free from damage, corrosion, dirt and oil.
The welding of block connectors should be in accordance with the relevant clauses of EC3.
The external PEG tubing and connectors should be cleaned regularly with warm, soapy water.
Periodically, the cables and connectors should be inspected for damage, corrosion, dust, and dirt.
Which card and connectors should I buy to display the 4K?
You'll also be interested in:
Examples of using Connectors
Show more
Power connectors are located below the servodrive
Plug in the aileron connectors into receiver
The connectors are secured using a friction system
