Examples of 'control cycle' in a sentence
Meaning of "control cycle"
This phrase is often used in project management or quality control contexts. It refers to a series of steps or activities involved in managing, monitoring, and maintaining control over a process or system. It typically includes planning, executing, monitoring, and adjusting to ensure that goals and standards are met
How to use "control cycle" in a sentence
Basic
Advanced
control cycle
This braking control cycle is accompanied by noises.
The principal characteristics of the internal control cycle are as follows.
The control cycle may vary over time.
The result is then obtained after a single control cycle.
The driving pressure control cycle is controlled by solenoid valves.
They will be used for the next control cycle.
Control cycle for the part is realized after this has been rounded.
The correct switch combination is determined every control cycle.
The warning light flashes when a control cycle is activated while driving.
The sequence is then repeated for the next control cycle.
The control cycle lamp is flashing up to the end of the complete washing period.
The studies begin with spontaneous menstruation in a pretreatment control cycle.
Our solutions allow you to monitor and control cycle times more effectively.
A missed cycle is whenever the algorithm is not called during a control cycle.
The control cycle under this new approach will involve four main stages.
See also
The digital computer performs the control cycle tasks once every control cycle loop.
The control cycle lamps will be flashing until the end of the complete washing period.
For example there must be a good supply of information and a tested planning and control cycle.
The control cycle herein implemented confers to the system a quality control of the bent prosthesis.
You must maintain the standard values for the automatic kanban calculation in the control cycle.
Use the Wrinkle Control cycle to help minimize wrinkling.
This POU is called exactly once per control cycle.
Thus, one control cycle according to the valve control program is finished.
Each DI control beam appear twice in the control cycle.
Subsequently, the routine continues in the control cycle in a manner similar to that described above.
Each UL control beam appear once in the control cycle.
The duration of a control cycle is then reduced to 70 ms.
Thereafter, the processing sequence in the present control cycle is ended.
The duration of a control cycle is then only 20 ms.
A control circuit 6 defines control signals applies to the machine during a control cycle.
The readoff, checking and control cycle time is 5 ms.
Once the system is initialized, the digital computer proceeds to execute the control cycle.
The control cycle is then subsequently repeated in each half cycle of current 51.
Then, the processing of the present control cycle is finished.
A missed cycle is a control cycle period in which the ALGO 510 is not called.
Then, the processing in the present control cycle is finished.
When a control cycle interrupt occurs 〈 28 〉, the digital computer begins a new control cycle.
If necessary, you must maintain the detailed dependent requirements selection in the control cycle.
Figure 3 illustrates an exemplary control cycle of molecule G.
In one variant, the recording, evaluation and influencing take place in a closed control cycle.
By these means, a variable control cycle for the regeneration of tank 16a may be provided.
However, this figure includes expenditure, which has not yet gone through the full control cycle.
The table of FIG . 7 shows an exemplary control cycle of the multiplexer 4.
Otherwise, the mis-match will continue for the remainder of this particular process control cycle.
The operation of circuit 64 during a control cycle of transistor T C1 schematically is the following.
FIG . 2 contains a chart showing the variation of current in the coils during a control cycle.
Have you set up a Risk Control cycle yet?
The rear wheel lift-up judgment unit 26 repeatedly conducts judgment according to a predetermined control cycle.
Figure 12 illustrates control region, control region segment, and control cycle of a control beam.
The glucose time stamp tG [ K ] assigned is end time for the selected control cycle.
You'll also be interested in:
Examples of using Cycle
Show more
The cycle can be delayed up to nine hours
Press repeatedly to cycle through menu options
Cycle through different information display modes
