Examples of 'control horn' in a sentence
Meaning of "control horn"
A control horn is a mechanical component used in various systems, particularly in aviation and model aircraft, to control the movement or position of control surfaces, such as the rudder or elevator. It is typically a lever or arm that connects the control surface to the control mechanism, allowing for manual adjustment or manipulation
How to use "control horn" in a sentence
Basic
Advanced
control horn
Ensure the control horn faces down.
Attach the linkage to the fl ap control horn.
Secure the control horn to the aileron.
Connect the linkage to the fl ap control horn.
Fit the control horn into position.
Connect the clevis to the fl ap control horn.
Install all the control horn at this time.
Connect the remaining clevis to the aileron control horn.
Secure the control horn to the control surface.
Attach the opposite clevis to the elevator control horn.
Insert the control horn into the slot.
Insert the linkage rod into the control horn.
Fit the control horn into position in the rudder.
Sand the lower portion of the control horn where it fi ts.
Glue the control horn into the aileron using epoxy.
See also
Temporarily attach the ball link to the control horn.
Check the fi t of the control horn in the slot on the aileron.
Connect the clevis to the outer hole of the fl ap control horn.
Mark the locations for the control horn mounting screws.
Connect the clevis to the outer hole on the fl ap control horn.
Check the fi t of the fi berglass control horn in the slot in the aileron.
Attach the clevis to the middle hole of the elevator control horn.
Position the control horn at the mark made in the previous step.
Follow the procedure outlined in the aileron control horn installation.
Position the control horn so the screw faces toward the wing tip.
Attach the linkage to the servo arm or control horn after adjustment.
Fix the control horn with the delivered screws and nylon support.
Attach the clevis to the center hole of the rudder control horn.
Position the screws in the control horn toward the top of the rudder.
Connect the linkage to the servo horn and aileron control horn.
Mark the center line for the control horn on the control surface.
Connect the clevis to the center hole of the aileron control horn.
Attach the clevis to the elevator control horn see instructions for clevis connection.
Thread the screw through the ball end and control horn.
Place the control horn so the hole aligns with the center of the hinges.
Remove the outer hole of the fl ap control horn using side cutters.
There are two slots in the elevator for the installation of the control horn.
Remove the screw from the control horn after the epoxy has fully cured.
Use a hobby knife to carefully cut the slot for the control horn.
Insert the elevator control horn into the slot in the elevator from the bottom.
Follow the procedure outlined for the aileron control horn installation as a guide.
The control horn is the part on the elevator where the pushrod and clevis attach.
Prepare each of the cables for the rudder control horn at this time.
Install the elevator control horn following the same procedure as the aileron control horns.
Use side cutters to trim the excess screws above the control horn backplate.
Attach the aileron control horn to the Y-Harness in the fuselage.
Connect the linkage to the servo horn and center hole of the aileron control horn.
Do not adjust the control horn or loss of control and / or a crash may occur.
Be sure that the conical spacer is placed between the ball link and control horn.
Screw the control horn in place with the 2 delivered screws and the nylon support.
You'll also be interested in:
Examples of using Horn
Show more
The long horn is their call to battle
Please tell me that that was the horn
The vehicle horn will sound simultaneously
