Examples of 'control signal s' in a sentence
Meaning of "control signal s"
control signal s - signals used to manage or direct the operation of a system or device
How to use "control signal s" in a sentence
Basic
Advanced
control signal s
This signal constitutes the measurement signal S m and the control signal S c.
Each switch SW i is controlled by a control signal S i supplied by a control unit 22.
The control signal S is produced by a control circuit 3 in response to a switching demand DCOM.
Such switching element T1 may be controlled by a control signal S applied to the control terminal 3.
Control signal S 4 thus changes from the low state to the high state.
The selection element receives the signals FI and FQ of each branch and a control signal S 0.
This connection allows control signal S 4 to act directly on signal S 1 and modify it.
Control unit 20 which controls the first switch by supplying it with a control signal S 1.
Each contact 28 is suitable for controlling via a control signal S 1 the corresponding charging point.
The sampling control signal S 3 may be formed and delivered by the pulse generating means 120.
As of an instant t 0, the feedback control signal S 7 changes state.
The control signal S 1 is transmitted via the second electric line 26.
In that case, the first switch is controlled by first control signal S 1.
This switch receives a control signal S 1 from a control unit ( not shown ) to control its actuation.
Advantageously, synchronous filter 40 operates independently from the phase shift between signal S 6 and control signal S 9.
See also
The variations in the control signal S 32 are dependent on those of the excitation signal S 10.
Each switch SW i, 2j is controlled by a control signal S i, 2j.
By sending a single control signal S to the contactor 4, the two switches I 1, I 2 are then simultaneously controlled.
Each control device 820 is suitable for transmitting the control signal S 1 to the corresponding charging point 818.
The control signal S 0 is at the “ 0 ” state in this positive integration phase.
In step 120, there is produced a control signal S which orders the lock to be opened.
Control signal S 1 is at the “ 0 ” state in this negative integration phase.
In this mode, the control signal S 21 maintains the active switch 21 in the open state.
Control signal S from optic sensor 14 is applied to input E 2 of comparator circuit 19.
Finally, the control signal S 2 is obtained by the inverter 35 inverting the signal S 2 b.
When the control signal S shifts to 1, the transistor T 1 goes into the on-state.
You'll also be interested in:
Examples of using Signal
Show more
Give me a signal when you want me to start
You have to use one signal at a time
Signal strength indicating connection between units
