Examples of 'cooling time' in a sentence
Meaning of "cooling time"
cooling time - refers to the period required for something to cool down, usually after it has been heated or used
How to use "cooling time" in a sentence
Basic
Advanced
cooling time
Cooling time of five minutes must be followed.
There is no increase in component weight or cooling time.
Effective cooling time during average use.
Total time does not include cooling time.
When cooling time is added or collecting of firewood.
Reduces the cooling time while.
The cooling time is also greatly increased.
This reduces the cooling time.
The cooling time may be relatively short.
This condition is maintained for the cooling time.
Cooling time is proportional to square of wall thickness.
Allow sufficient cooling time prior to applying device.
Cooling time depends on local conditions.
Set the desired cooling time in the cooling timer.
Cooling time is long enough for auto ejection to occur.
See also
It can be used again after half an hour of cooling time.
And the cooling time controllable.
The discharging time is less than the cooling time.
The cooling time of the tank is therefore substantial.
To reduce the cooling time.
Remaining cooling time is shown during drying and cooling.
The thickness finally allows the cooling time to be estimated.
The cooling time is generally on the order of a few seconds.
Processor has had sufficient cooling time to cool before handling.
The cooling time of the polymer is then relatively long.
Reduced cooling time.
The cooling time is normally written on the tag of the fitting.
Seconds cooling time.
Cooling time and temperature settings can be adjusted at any time.
Follow instruction manual recommendation on the cooling time before opening.
After a short cooling time the polymer solidifies.
It was checked that phase transformation kinetics is favored by a longer cooling time.
In addition the cooling time of the film is equally rapid.
Relationship between the welding conditions and the cooling time.
The effect of cooling time on burnup and radiotoxicity was then ascertained.
Other constants could be selected depending on the tissue cooling time.
The cooling time must be the same as the blanching time.
This aspect shows the effect of cooling time on the production.
The total cooling time can not be longer than six hours.
Relationship between the welding condi tions and the cooling time.
It is only after some cooling time that the machine can be restarted.
So the key question here is the relationship between characteristic cooling time.
During this extended cooling time shrinkage is much more likely to occur.
The calculation formula also differs depending on the definition of cooling time.
The cooling time and thereby the injection cycle time are reduced.
Probably set to the number of rotations that end in the cooling time.
This decreases the cooling time required before opening the mould.
The traditional processing method is natural cooling and long cooling time.
This reduces the cooling time required before opening the mould.
Brittleness and crystallization were found to be impacted by cooling time of the extruded rod.
