Examples of 'cross head' in a sentence
Meaning of "cross head"
The term 'cross head' has different meanings depending on the context. In the mechanical or engineering field, it typically refers to a mechanism or component that connects two reciprocating parts, allowing them to move in a synchronized manner. In the context of journalism or writing, a 'cross head' is a subheading or title that appears within an article or text
How to use "cross head" in a sentence
Basic
Advanced
cross head
The cross head structure is also available.
Elongation at break was measured by cross head movement.
Use a cross head screwdriver to remove.
It is not known what the cross head was supporting.
Cross head full thread screw.
Turn the setting screw with a cross head screwdriver.
The cross head looks big.
The vacuum tubes can be installed on the blower using a cross head screw driver.
Cross head of the frame.
Lower cross head.
One cross is in the churchyard and the other is half a cross head at Treffry.
Fortunately the cross head and bearings were in good condition.
Converting the blower to a vacuum / silencer is simple and can be done using a cross head screwdriver.
Upper cross head.
Apply the height adjustment crank ( i ) with the cross head screw.
See also
This coating cross head is advantageously positioned with a vertical axis.
Treneague Cross consists of an ancient cross head mounted on a modern shaft.
Using a small cross head screwdriver remove the screw inside the hairpocket.
Click the cylindrical face of the Pan Cross Head shaft as illustrated.
Use a cross head screwdriver to remove the six retaining screws K.
Remove the two, small cross head screws securing the.
The cross head speed was set at 12 inches per minute.
Secure the bar with the 2 screws supplied cross head screwdriver not supplied.
The upper cross head 7 returns to its starting position.
Testing was performed at a cross head speed of 1 mm / min.
Undo with cross head screw driver the four screws 2 upper on each side.
The measurements were performed with a constant cross head speed of 2mm/s.
After sample mounting the cross head distance was zeroed and the test started.
Mount the cable support ( gg ) and refit the cross head screw.
A certain cross section of the cross head is also required due to static requirements.
The cross head was extended at a rate of 200 mm / min until the sample broke.
Hingedly mounted to the cross head 6 is a retractable balustrade 10.
When the cross head stops, the pad is turned upside down and test is repeated.
The overlapped joint was then peeled apart at a cross head movement rate of 20 mm / min.
In figure 1 cross head 7 operates in pushing mode whereas cross head 11 operates in pulling mode.
A specimen gage length of 50 centimeters and a cross head speed of 50 centimeters per minute are used.
The Instron cross head moved at 12 inch / min to propagate the tear along the sample.
In the drawings, 2 is an autograph cross head and P is a plate.
During the measurement, the cross head progresses with a speed of 6 mm per minute.
The gauge length was 1 inch and the cross head speed was 25mm/minute.
However, the installation of the cross head then frequently interferes with other production operations.
Legs 1 height adjustment crank 1 cross head screw 1 saw blade 1 guard assembly.
The reference 10 designates the cross head extruder body which terminates in the extrusion die 11.
Figure 10 illustrates the load cross head displacement diagram as discussed in Example 5.
Fig . 5c shows a cross head in side view.
