Examples of 'dead band' in a sentence
Meaning of "dead band"
dead band: This phrase can have different meanings based on the context, such as a range of values or settings where no action is taken or a lack of response or activity in a particular situation
How to use "dead band" in a sentence
Basic
Advanced
dead band
Dead band is usually expressed in percent of span.
You look like a dead band leader.
A dead band can also be set.
This phenomenon is called dead band or hysteresis.
These requirements do not consider uncertainty caused by dead band.
For each command value a dead band can be set.
Dead band minimum.
This vicinity is designated dead band.
The dead band is decreased to b until the error is within the reduced dead band b.
Also called dead band.
Dead band control can avoid unnecessary intermittent operation by smoothing out measurement excursions.
Both a narrower and a wider dead band may also be applicable.
The value set defines half the width of the dead band in.
Dead band for eliminating the smallest signal levels ④.
For every command value a dead band can also be set.
See also
Zero crossings are not counted while the signal is in this dead band.
They are a dead band.
The front rack actuator control contains a function defining a front rack dead band.
Hereby it is ensured that said frequency dead band comply with existing grid codes.
This is setting that adjusts when fast drop rate starts with respect to dead band.
To avoid unnecessary actuator hunting, some dead band provision may be provided.
However, precision and slalom performance is compromised by dead band.
In fact the dead-zone imposes a dead band on the speed error.
We keep venting, we are gonna keep hitting the edge of that dead band.
Once the error falls within the dead band b, the dead band is again increased to B.
This arrangement ensures that the pressure controller 16 never enters its dead band.
But how is the dead band determined?
The heavy sub-set H is displaced when the group P 1 reaches the limits of the dead band.
Curve 230 represents a dead band limit of the average state of charge.
DB Mode, The function is used to test the dead band of servo.
Section 370 represents the dead band limit of the average state of charge.
The difference is compared to a predetermined pulsation levels dead band B by limiter 13.
Dead Band, You can set the dead band for the 1st relay alarm.
This was the so-called dead band.
Dead Band, You can set the dead band for the 2nd relay alarm.
For other uses, see Dead band.
Well, I am sure the dead band is gonna be totally bitchin ', but I have curfew.
Heat set point and Cool set point must be separated by a 5 F/3 C dead band.
Changing 104 of blade pitch includes a dead band to accommodate, for example, gear backlash.
The dead band “ db ”, area without commands to the servomotor, Parameters level.
And the diagnostic module will use a dead band of 5 r . p.m.
You'll also be interested in:
Examples of using Band
Show more
Select frequency band and radio station
My band was supposed to perform in the festival tonight
They are inside the band today they are going in
Examples of using Dead
Show more
A dead tiger can not harm you
You saw that dead guy in there
Two dead men laying there because
