Examples of 'delay t' in a sentence
Meaning of "delay t"
delay t: This phrase could refer to a delay in time or schedule, where 't' might represent a specific duration or time frame
How to use "delay t" in a sentence
Basic
Advanced
delay t
The delay t may be a fixed or a variable delay.
Each of these elements causes a delay t equal to the duration of a block.
The delay t introduces a frequency shift fb.
PMD may be modeled using a delay t.
This slight delay t may be of the order of several nanoseconds.
The processed pulses themselves have been shifted by a delay T purposely magnified in the drawings.
Note that the delay t between two consecutive fields is a stochastic variable.
This transition corresponds to a singularity in the signal s allowing the delay T generated to be detected.
The fixed delay T determines the range of adjustment of the delay.
The amount of data requested may depend on the target buffering delay T to be met.
The delay t corresponds for example to Tm divided by the number N of transmit subarrays.
A procedure for reinitialization and disabling of this second time delay T unstable is also defined.
The signal HFLY has a delay t with respect to the drive signal HDRIVE.
The combined signal thus obtained is characteristic of the delay t 0.
This START pulse is shaped with a delay T and a programmable width δ.
See also
Delay t may be obtained by internal generation of a signal CSEINT common to all circuits 14.
We obtain for the delay t expressed in ms,.
In order to observe different states of the microsystem, delay t is modified.
If time delay T a has ended.
Within a first time, the effect of the jitter on the delay T ps is calculated.
This very short delay t 1 may be of the order of several nanoseconds.
Note that timestamping of the time of flight is affected by inaccuracy, namely delay T det.
In pulsed operation, an initiation delay t is produced on each pulse.
The delay t tot seq is then transmitted to the emitter ( identified by the offset C v ).
Phases φi depend on the delay t introduced by the delay line,.
This signal reproduces the signal f1 with the delay T.
This signal is deferred in time by a delay t by means of a delay line 5.
Once the optimal delay T is found, the corresponding correlation value is compared against a threshold.
The signal ACK 4 can then be transmitted after the expiry of the delay T EC.
In the illustrated example, the delay t is applied to the first polarization signal.
Each path has an incidence u 1p and a delay t 1p.
Switches each configured to delay the power supply to the electric motor with a delay t ret ;.
The filter 96 thus eliminates pulses of a duration less than the delay t.
These buffers will impose a delay T ± δt, where δt represents a jitter component.
In a step 55, closing of the secondary breaking device is commanded after a time delay T 2.
The time delay T unstable disappears, or if.
The signal r ̂ ( n ) is used to compute the pitch delay T and gain g pit.
Time delay T unstable has elapsed, or if.
Each radiating element is affected by a delay t k, produced in accordance with FIGS . 1 and 4.
The delay t 5 is applied in the same way.
The management of this other time delay T 2 is described below in relation to FIGS.
The time delay T 1 allows the actuator control module 8 sufficient time to withdraw the pusher 5.
The measurement of the group delay T 1 is quite fast, about a few minutes.
Furthermore, the frame of the ACK 1 signal is prepared during the delay T w.
During this time delay T unstable, observation of the vehicle deceleration is performed.
First branch comprising a delayer module, introducing a delay T d of the signal V ( t ) ;.
The best open-loop delay T op is determined as follows,.
FIG . 4 represents the principle of initialization, maintenance and decrementation of the time delay T unstable ;.
The adjustment signal is transmitted with a delay T to the module 7, imposed by the delay element 6.
Line ( b ) of FIG . 4 shows the wave train received by a probe after a delay t.
You'll also be interested in:
Examples of using Delay
Show more
Recording delay occurs during locomotive power up
Damaged gaskets must be replaced without delay
Delay in treatment can lead to amputation or death
