Examples of 'design load' in a sentence
Meaning of "design load"
design load - In engineering and construction, design load refers to the specific amount of force or pressure a structure is intended to withstand without failing. This term is commonly used when calculating the requirements for building materials and structural components
Show more definitions
- The total load on a structural system for the most severe combination of loads and forces which it is designed to sustain.
How to use "design load" in a sentence
Basic
Advanced
design load
Are testable under design load conditions.
The design load of synthetic georeinforcements.
Estimated design load.
Design load bearing capacity.
Relationship between design load and number of shear connectors.
Design load condition.
The total chiller plant is sized to supply maximum design load.
Wg is the design load carried by the steel member alone.
The fundamental rule is that the design load should not be exceeded.
The hydraulic cylinder sets the binding load to the design load.
Thus the design load of a horizontal axis wind turbine can be greatly reduced.
Correct installation techniques are paramount to meet engineered design load and settlement outcomes.
The design load of the turbine can also be referred to as the nominal load.
This again may be considerably higher than the steady-state design load.
This Standard provides minimum design load requirements during construction for buildings and other structures.
See also
Where the concrete tensile stress exceeds the allowable design load - there is a crack.
The design load is always an axle load ; single wheel loads should not be considered.
As a result, even relatively small increases in total roof design load lead to reinforcing requirements.
The lateral design load ( NTDL ) for a propeller nozzle is determined from the formula.
All four test specimens sustained the maximum design load for approximately 2 hours without collapsing.
Design load for cooling in kW, rounded up to one decimal;.
V where S, is the design load effect at fire.
Design load capacity - psf.
Fig. 9 depicts a design load comparison graph.
He said the corps applied a 30 % margin over the maximum design load.
Loads different from the design load will give increased transmission error . ".
Curve 508 represents a predetermined threshold, which is typically reflective of an allowable design load.
LDL ” is the horizontal length of the design load determined according to section 14.
The design load ( RDI ) for a rudder is determined from the formula.
Values for heating seasons for which design load is not provided shall be indicated as ‘X';.
The right-hand side of Fig . 2 illustrates the functionality protecting against exceeding of the design load.
Cable 42 is pre-tensioned above the maximum design load of cable drive device 10.
These ANSI Tier loadings have a corresponding test load which is 50 % greater than the design load.
Design load is cycled 10 times, followed by applying the test load . FIG.
Figure 12 shows, however, that even in case of total design load.
In the new draft a value of 1/600 for deformation under design load therefore is proposed.
In one example, the ANSI Tier designations relate to the normal design load x 1000 lbs.
You'll also be interested in:
Examples of using Design
Show more
Guidelines for the design and installation
The design of the study was fairly straightforward
Specifications and the design are subject to possi
Examples of using Load
Show more
You can load up to five discs at once
Suppose you walk by with a load of cement
Lower the load to the bottom point
