Examples of 'diameter should' in a sentence
Meaning of "diameter should"
diameter should: This phrase implies a recommendation or requirement for a specific measurement related to the diameter of an object or structure. It indicates that the diameter of something is expected to meet a certain standard or criteria for accuracy or functionality
How to use "diameter should" in a sentence
Basic
Advanced
diameter should
The alignment tyre outer diameter should be.
The diameter should be the same at both ends.
I think a spring of this diameter should be fine.
Pot diameter should match that of the cooking zone.
The next highest standardised diameter should then be chosen.
The outside diameter should be fixed by agreement when ordering.
Only flow regulating valves with the same hole diameter should be combined.
Overall tire diameter should be maintained.
For example, if the spacing is increased, the plate diameter should be decreased.
Thus their diameter should not be too large.
A minimum 3:1 taper of the inside diameter should be utilized.
Outside diameter should be the same.
In this case, a greater insert diameter should be applied.
Its diameter should be equal to that of the plant to uproot.
Potatoes under the minimum or over-the-maximum diameter should be weighed to determine the percentage.
See also
The neck diameter should be measured perpendicularly to the blood flow.
For non-visible varicose veins, the diameter should be measured by ultrasound.
This diameter should be smaller on trees that compartmentalize decay poorly.
Thus, the length of the smallest tube diameter should preferably satisfy the following relationship.
Their diameter should be equal or somewhat larger than that of the heating fields.
The fixing bolt head diameter should be more than 12mm.
This diameter should be no larger than the smallest intended diameter of the implanted device.
For example, a bulb 2 inches in diameter should be planted about 6 inches deep.
The diameter should be consistent, and must not increase towards the muzzle.
Any log over 6 ” in diameter should be split.
Particle diameter should be understood as meaning the diameter of the unit particles.
Therefore, the foyer chandelier 's diameter should be approximately 28 ” in width.
Ductwork diameter should be sized to minimize losses for the volume of airflow required.
It is assumed that the relative variations in diameter should not exceed + 5,,.
The out side diameter should be fixed by agreement when ordering.
In this case, the mean mass particle size diameter should preferably be between 15 and 75 µm.
The internal diameter should be measured or refer to the specifications of internal diameter pipe.
Needle length and diameter should be adapted to the age of the animal.
A diameter should be cut to size in two cuts, an roughing cut and finishing cut.
The inside diameter should be 5mm or larger.
The rope diameter should be uniform throughout, following a short break-in period.
The inner pipe diameter should match the outlet size of the appliance.
The diameter should be greater or equal to " d ".
Thus its linear diameter should be about 14 light years.
Crown diameter should be about 50 cm smaller than the thickness of coal seam.
What diameter should it be.
Duct diameter should be at least 30 times the diameter of the Pitot tube.
Note that the hole diameter should not be greater than 0.7 centimeters.
The stock diameter should never exceed the thread major diameter.
Its diameter should.
Discharge pipe diameter should be equal to or larger than discharge size of pump.
Suction hose diameter should be at least as large as the pump intake opening.
The particle diameter should be chosen so as to be smaller than the fiber diameter.
The pulley diameter should never be smaller than the width of the belt.
The flue 's diameter should be the same throughout its whole length.
You'll also be interested in:
Examples of using Diameter
Show more
A change in wire diameter results in changed parameters
Diameter of and pressure in the fire mains
The incoming hole diameter on auxiliary terminal
