Examples of 'drive roll' in a sentence
Meaning of "drive roll"
Drive roll could refer to a mechanical component in machinery or equipment that helps propel movement or rotation, often found in industrial or automotive settings
How to use "drive roll" in a sentence
Basic
Advanced
drive roll
Drive roll with too large a groove.
Position it as close as possible to the drive roll.
Check drive roll tension and position of.
Hex key wrench for removal of drive roll.
Reverse the drive roll as follows.
Use a small wire brush to clean drive roll.
Replace point and drive roll pin in place.
Clean the wire groove on the drive roll.
Check for proper drive roll orientation and alignment.
Drive roll size is stenciled on each side of the drive roll.
Remove the lower drive roll and inner wire guide.
A drive roll is mounted at a fixed location for rotational movement.
Pivot arm assembly with bearing pressing against drive roll.
Top drive roll pressed against lower drive roll.
The stationary strip is preferably located below the lower drive roll.
See also
Top drive roll pressure arm tension adjustor down.
Make sure the wire is positioned in the groove of the lower drive roll.
Install proper drive roll for the wire size selected.
Lift up on feed handle and place pipe on drive roll and pipe support.
The drive roll has a groove to match the specific wire type and diameter.
At the same time the spring acts to disengage the drive roll drive.
Remove drive roll by turning the twist lock that holds the drive roll on.
This might accumulate in the front drive roll and block the conveyor belt.
Drive Roll tension is set too high.
Turning clockwise increases the force on the drive roll and turning counterclockwise decreases the force.
If drive roll flange shaves pipe end, decrease offset dimension.
Lower the pressure roll assembly and adjust the drive roll pressure to make sure that.
The drive roll assembly of claim 8 further comprising,.
Misalignment of the drive roll groove Realign.
Remove wire from the feed mechanism, remove screws from the drive roll housing.
This objective is solved by a drive roll assembly according to claim 1.
Winding is performed as before by means of a drive roll 16.
Figure 8 is a plan view of the lower drive roll shaft of the statement printer.
The drive roll assembly of at least one of claims 1 to 9 further comprising,.
Guides the wire between the Top and Bottom Drive Roll and through the wire drive.
A delivery roll 4 supplies the yarn to a package 2, which is driven anticlockwise by a drive roll 1.
In the rewinder, the paper web turns around a drive roll 8 on to the customized reel.
The drive roll 51 has an idler roll 53 nipped against it to form a nip roll assembly.
Clean dirt and metal particles from drive roll groove weekly ; replace roll if badly worn.
See MAINTENANCE section for proper contact tip, nozzle liner and drive roll configuration.
Figure 2 is a detail view of a drive roll 18 and a portion of a backup roll 20.
Make sure that the wire goes into the groove of the drive roll B fig.2.
A drive gear 46 is secured to the drive roll 42 and rotates with the drive roll.
Reversible, dual groove drive roll.
Refer to Table C. 1 for various drive roll kits that are available for the WIRE FEED 255.
Pipe axis not offset 1/2 degree from drive roll axis.
When using the FCAW process, the correct drive roll and electrode polarity must be used.
When using the GMAW process, the correct drive roll and electrode polarity must be used.
The cutter guide insert 56 mounts into the drive roll and is secured by a fastener post 55.
It should be noted that pressure roll 24 and drive roll 17 may optionally both be heated.
