Examples of 'drug load' in a sentence
Meaning of "drug load"
drug load - The quantity of drugs being carried or transported
How to use "drug load" in a sentence
Basic
Advanced
drug load
A low drug load may cause homogeneity problems.
Increased solids concentration resulted in increased drug load.
High drug load mesalazine sachet.
Or you died because you had a drug load.
A free drug load.
You died because you lost a drug load.
The drug load had also a significant influence on release kinetics.
This trend parallels the trend of the drug load.
Both compositions with medium drug load were successfully compacted into ribbon.
Core compositions of Seletracetam pellets with high drug load.
This kind of treatment regimen requires a high drug load in a slow release formulation.
Core compositions of Seletracetam pellets with low drug load.
The formulation with a high drug load in the layer can also contain a surfactant.
The unveiled core then disintegrates, releasing its drug load.
Such balance of adhesive properties and drug load render a device suitable for therapeutic uses.
See also
As the drug load is increased . the initial burst increases and the duration decreases.
The conjugate is then analyzed for final drug load and monomeric purity.
This off-target drug load causes adverse effects that limit the usability of the drug.
For example, there is a need for emulsions having a higher drug load and / or a better safety profile.
High drug load pellets were prepared according to the composition given in Table 5.
Figure 6 illustrates the effect of drug load on the release profile of PLGA-bevacizumab implants.
The tablets were compressed from a common blend, while varying the drug load for different strengths.
In the wafer configuration, drug load also determines the duration of drug release.
Drug load is adjusted to a percentage, which allow for filling of 5 mg into capsule size 0.
Dispersed colloidal systems permit a high drug load in the formulation without the use of co-solvents.
Low drug load pellets were prepared according to the composition given in Table 1.
Doxycycline hyclate was loaded into another 1 ml syringe to give a drug load of 8.5 percent doxycycline.
The resulting drug load aimed to 30 % by weight.
Most of the fluocinolone acetonide formulations released the total drug load in approximately 2-3 months.
Drug load was determined by UV spectrometer at 318 nm.
Figure 2 and 3 show the effect of charge on drug load and loading efficiency.
Again, the kinetics of diltiazem release are zero-order for greater than 80 % of the drug load.
Initially the higher drug load at 85 % active is evaluated.
According to the following examples and experiments, the proper drug load should less than 30 %.
Drug load was approximately 1.9 ( Table 15 ) showed a significant inhibition of tumor growth during the study.
Released approximately 31 % of the drug load in the first 6 hours.
The current validated vildagliptin formulation is a DC ( direct compression ) tablet with a 25 % drug load.
The implant releases ∼ 15 % of the drug load over the first month.
Fig . 1, Impact of oxidizing impurity on drug load.
This platform allows for a very high drug load of up to 1,000 mg in a single dose.
Large amount of Metformin, hence large tablets and low LAF237 drug load.
A higher aqueous solubility would increase drug load per unit dosage of VX-478.
During the next 8 hours only 34 % of the drug load is released.
The insert 27 would then be removed leaving the drug load 31 within the urethra.
