Examples of 'dry compressed air' in a sentence
Meaning of "dry compressed air"
dry compressed air - This phrase refers to air that has been stripped of moisture and compressed to a higher pressure for specific industrial or commercial applications
How to use "dry compressed air" in a sentence
Basic
Advanced
dry compressed air
Dry compressed air available without delay.
Requires the use of dry compressed air.
Use only dry compressed air for cleaning.
For the transmission of clean and dry compressed air.
Blow dry compressed air through the ventilation.
Clean motor by means of dry compressed air from the outside.
Dry compressed air may be used to blow out container.
It is best to clean the power tool with dry compressed air.
The dry compressed air leaves the membrane element.
No additional space is required for the generation of dry compressed air.
Using dry compressed air.
The elastomeric tip is dried with clean dry compressed air.
Do not dry compressed air more than the application requires.
Through the ventilation holes with clean and dry compressed air.
Use dry compressed air to blow the motor compartment out from the outside.
See also
This process can be accelerated by using dry compressed air or dry nitrogen.
Remove parts with dry compressed air and apply new grease with clean hands.
Periodically blow out all air passages with dry compressed air.
Dry compressed air can be fed through the fluidising plate at a controlled rate and pressure.
Take your portable air tank to any source of clean dry compressed air.
Dry compressed air at a pressure of 4 bar.
It is important to carefully clean the machine after each use with dry compressed air.
In addition, the dry compressed air must be immediately available.
Regularly blow out the housing interior and motor with dry compressed air.
Housing using clean, dry compressed air is a suggested maintenance procedure.
Blow the two inside volumes of the equipment with clean dry compressed air.
Consequently, dry compressed air is blown onto the ink nozzles.
Follow the maintenance instructions below to blow dry compressed air into the ventilation ducts.
Why dry compressed air is so important?
Periodically clean the lower part of the casing and the motor with dry compressed air.
Inert gas or purified, dry compressed air is required for operating the unit.
KELTEC Refrigerated Dryers actively remove condensate to achieve extremely dry compressed air.
In almost every process, clean and dry compressed air will result in lower operating costs.
Clean it periodically along with the gas lines, using dry compressed air.
The strip is air-cooled by blowing dry compressed air into the tunnel at approximately 10 CFM.
Clean the left side of the power source using low-pressure dry compressed air.
Clean the power source with dry compressed air ( 4 bar ) as follows,.
The cloud was generated by blowing the dust for 1 second with clean, dry compressed air.
Always use clean, dry compressed air.
Blow dust and grit out of the motor housing regularly using clean, dry compressed air.
Dry compressed air is delivered vía an inlet 51 into a hollow-fiber membrane module 50.
Connect ionizer to a supply of clean, dry compressed air.
Use only clean, dry compressed air with a maximum pressure of 200 psi.
Clean it periodically a lines, using dry compressed air.
The hose should be dismantled every week and blown out with clean, dry compressed air.
In a preferred embodiment, nitrogen or dry compressed air are used.
Periodically clean dust and debris from the Quik-Lok Blade Clamp with dry compressed air.
Ozone was produced using an OZV-8 generator with dry compressed air feed.
You'll also be interested in:
Examples of using Dry
Show more
Dehumidifier does not dry the air as it should
Let it dry completely before starting it up again
Dehumidifi er does not dry the air as it should
Examples of using Air
Show more
Air sealed in hydraulic system while operating
Application of the air limited quantities mark
The air will be full of jets in a minute
Examples of using Compressed
Show more
Clear with compressed air or replace liner
The hose should not be bent or compressed
Use compressed air to remove stubborn debris
