Examples of 'dry contact' in a sentence
Meaning of "dry contact"
In electronics, a dry contact refers to a circuit that does not carry any current when closed. It is typically used to provide a signaling or control interface between different systems
How to use "dry contact" in a sentence
Basic
Advanced
dry contact
Dry contact relay output for faults.
Connectors for dry contact input.
Dry contact just activates the system.
Using the camera as a dry contact.
Dry contact relay to control any device.
Compatible with devices featuring dry contact connections.
Dry contact outputs to send alarm signals.
It was a dry contact lens.
Dry contact relay output for ire and fault.
It is also possible to receive information through dry contact interface.
Requires dry contact closure to activate.
From any remote control device equipped with a dry contact.
Converts to dry contact by changing internal jumper switches.
The connection between the motor and the receiver is made by a dry contact.
Dry contact terminal bushing for low voltage connection.
See also
Fault dry contact.
A dry contact adversely affects picture quality and motors operation.
Solutions for programming palmtop programmer for tubular motors featuring dry contact cable or ttbus.
Dry contact inputs for connecting a keypad or other control systems.
Cancel mode for use of Dry contact for setback.
Dry contact card.
Terminal connections DPDT dry contact switch with silver contacts.
Output dry contact for information on the barrier or to command other equipments.
Sensor for window frames with dry contact Reed switch.
Dry contact refers to a contact of a relay which does not make or break a current.
Palmtop programmer for Nice tubular motors with TTBus technology or dry contact.
One dry contact output for a maximum compatibility with every automated systems.
Start and stop signals to external heat source are given by NESTOR through a dry contact.
One dry contact output on a tiny circuit to insert into your lock block.
The indoor unit can not be controlled through the Dry contact for setback.
Dry Contact can be used in two ways.
Requires constant power and SPST dry contact switching.
No dry contact with a source of DNA has been explored previously.
Control System Input controlled by dry contact.
The dry contact reopens again when the UPS returns to inverter mode.
Controlled Off Cycle only if HP is controlled by dry contact.
The Dry Contact product outputs can be configured as outputs for controlling the equipment.
Input Dry contact.
Dry contact interface settings for extended communications of EMi3 stabilizer.
For detailed functions related to the dry contact mode, refer to the dry contact manual.
Original dry contact design, achieve the switch of external equipment.
Supported sensors: Any contact without external voltage dry contact.
Standard dry contact for input / output interface.
The ON / OFF contact of the heating system controls must be a dry contact.
Dry contact communications are simple, but some knowledge of electronics is necessary to configure them.
This section displays current states of dry contact inputs, including alarm status and settings.
Dry contact interface settings for extended communications of DC Power-S.
Out of Safe Range - Response to the Alarm state activation/deactivation for dry contact inputs.
Dry contact interface settings for standard communications of RE3 stabilizer.
Non-voltage dry contact water meter.
You'll also be interested in:
Examples of using Contact
Show more
I have little contact with the neighbours
Contact officer for national report if different
We can not contact the victim either
Examples of using Dry
Show more
Dehumidifier does not dry the air as it should
Let it dry completely before starting it up again
Dehumidifi er does not dry the air as it should
