Examples of 'edge of the blade' in a sentence
Meaning of "edge of the blade"
Refers to the sharp or pointed side of a knife or any other bladed instrument. It can also be used metaphorically to describe a situation or position that is particularly delicate or dangerous
How to use "edge of the blade" in a sentence
Basic
Advanced
edge of the blade
The edge of the blade is very sharp.
Avoid the sharp edge of the blade.
The edge of the blade tucked up under her windpipe.
Do not touch the edge of the blade.
Place the edge of the blade perpendicular onto the skin.
Material is going to be removed from the edge of the blade.
Position the edge of the blade on rubber tire.
He could taste the sharp edge of the blade.
Clean the edge of the blade before sharpening.
Trailing or leading edge of the blade.
The cutting edge of the blade is only be resanded up to the imprinted markings.
Check to make sure the back edge of the blade is positioned.
The back edge of the blade should just touch the lip of.
Place the protection cap onto the edge of the blade.
By the edge of the blade.
See also
And then run the lighterover the edge of the blade.
The opposite edge of the blade is serrated for cutting.
The flaps are spaced along the trailing edge of the blade.
Both the back and edge of the blade are straight.
Coating failure is often observed on the leading edge of the blade.
Insert the cutting edge of the blade into the comb attachment.
Place the sealing ring in the lower edge of the blade unit.
Always keep the edge of the blade pointed away from you.
Try to avoid filing material off the sharp edge of the blade.
Press down on the blunt back edge of the blade until it is fully closed.
There are several ways of attaching a panel to the trailing edge of the blade.
The cutting edge of the blade is positioned horizontally and is parallel to the counterblade.
Remove all burr from the edge of the blade with a.
The sharp edge of the blade cuts a barb into the suture during each rotation.
And then run the lighter over the edge of the blade.
Make sure the back edge of the blade fits into the support roller.
A cutting surface can be provided at any desired exposed edge of the blade.
Make sure that the back edge of the blade fits into the roller.
Keep your fingers away from the sharp edge of the blade.
Handle the cutting edge of the blade very carefully when removing and adjusting it.
First type of blade has a spar arranged at the leading edge of the blade.
The back and the edge of the blade are parallel making it a very straight sword.
This facilitates the movement of the protrusion on the leading edge of the blade.
The peripheral cutting edge of the blade is serrated and hard faced to retain sharpness.
Coating failure due to erosion is often observed on the leading edge of the blade.
Make sure the bottom edge of the blade is fully seated against the blade holder.
Particular importance attaches to the cooling of the narrow trailing edge of the blade.
Edge of the Blade.
The edge of the splinterguard now corresponds exactly to the cutting edge of the blade.
Place the edge of the blade set 1 without a cutting length comb.
The fully tapered bolster allows for sharpening the entire edge of the blade.
Advantageously, the edge of the blade is chamfered to form the cutting edge.
Install the rear of the fence in line with the leading edge of the blade.
Remove all burr from the edge of the blade with a slip stone ;.
The laser beam may be emitted immediately adjacent the leading edge of the blade.
