Examples of 'edges must' in a sentence
Meaning of "edges must"
edges must: This phrase could mean that boundaries or limits need to be established or that specific requirements must be met
How to use "edges must" in a sentence
Basic
Advanced
edges must
Hole edges must be smooth and rounded.
The individual edges must overlap.
The edges must be carefully pushed together.
Blades must not be bent and the edges must not be damaged.
The soft edges must therefore be removed.
The triangle is an illusion dependent on a cognitive misunderstanding that adjacent edges must join.
All edges must be reasonably squared.
Not Acceptable Acceptable The game board including its outer edges must be shown.
Frame front edges must be aligned.
The edges must touch at their endpoints to form a topologically rectangular closed path.
All 4 forward change of edges must be performed.
Cutting edges must be offset equally on each side.
In particular, if r is odd then the number of edges must be divisible by r.
All edges must be fully radiused.
In order to build, sand with angular edges must be used.
See also
Both vertical edges must be the same length.
If there is a Hamiltonian cycle, an even number of these edges must be chosen.
The corners and edges must not be rounded or misshaped.
In order to keep the blade in balance, ail cutting edges must be sharpened equally.
All edges must be sharp.
When welding two tubes, their edges must be in perfect contact.
The edges must be crispy.
In order to keep the blade in balance, all cutting edges must be sharpened equally.
All sharp edges must be covered up by a protective film to prevent injury.
To eliminate the displacement the transverse edges must be movable / displaceable relative to each other.
All edges must be protected to keep anyone from slipping off.
For this reason, the edges must be prepared accordingly.
Tile edges must consistently match with respect to terrain types clear land, mountain, and water.
Likewise, all negative edges must go between the two groups.
Sheet edges must first be smoothed to remove the marks left by the circular saw.
When n is odd, the leftover edges must then form a perfect matching.
Roof edges must allow the tightness and durability of the roof.
Also during operation, the cutting edges must be kept absolutely in the correct position.
Fit the cutting blade E on the spiral feeder F, the cutting edges must be ahead.
The seams and edges must not cause harm to the user.
Thus every graph on n vertices with more than n - 1 edges must contain a cycle.
The adjacent edges must be pulled together during the final stage of the locking.
In such a case, the indicia edges must be non-parallel.
These two film edges must be sealed and the seal strength needs to be high.
N Place the cutting attachment ( 1 ) in position - the cutting edges must point clockwise.
The top edges must be filed down by the same amount for all the teeth.
The defect must be “ blunt ” - all sharp edges must be removed.
Longitudinal edges must be visible, mechanically stapled and glued.
In a graph with one vertex, all edges must be loops . Such a graph is called a bouquet.
Their edges must clear adjacent areas by 20 mm.
The ins and outs of their edges must be very many, who knows their number?
The cut edges must then be cleanly sealed 32 again.
The remaining edges must all be passive, with no upper lips.
The cover edges must contact the rear and side purple cover stops Fig . 11 detail arrow.
