Examples of 'elongation to break' in a sentence
Meaning of "elongation to break"
elongation to break: This phrase could refer to the process of stretching or extending something until it reaches its breaking point
How to use "elongation to break" in a sentence
Basic
Advanced
elongation to break
The elongation to break also increases slightly.
The load at break and elongation to break was recorded.
The laminate was very stiff and exhibited a low elongation to break.
Elongation to break values were, however, significantly reduced.
Extensibility or elongation is measured by elongation to break.
The elongation to break of the obtained coatings reported in this document is above 300 %.
This modification typically results in an improved elongation to break and toughness.
Elongation to Break ( % Elongation ) is the percentage elongation in a sample from start to break.
The drawing conditions depend on the polymer molecular weight and desired elongation to break.
The elastomer should have an elongation to break of at least about 50 %.
The formulated materials exhibited good mechanical properties, in particular good elongation to break.
The elastomeric yarn 20 is characterized by an elongation to break of at least about 70 percent.
Unfortunately, a composition providing good high temperature resistance often exhibits a poor elongation to break.
Figure 19 is a scatter plot of elongation to break vs. micronaire.
The elongation to break before aging is considered to be equal to 100 %.
See also
Neat converted starch exhibits enhanced processability but lower strength and elongation to break as expected.
Denier fiber with 30 % of elongation to break was the target.
FIG . 6 is a chart comparing steam flow versus filament elongation to break.
Figure 13 is a histogram of elongation to break a single fiber ( % of original fiber length ).
B-With the same bio-based content, the films have a greater elongation to break.
The yarn of Claim 1 having an elongation to break of at least about 10 %.
Tensile elongation to break is measured in accordance with ASTM D 638 with results reported in percent, %.
Parylene is used as the lubricant because it has a typical elongation to break performance of 200 %.
A large increase in elongation to break at 50°C is shown by all compounds containing 20 phr SCP.
The fiber of claim 1 wherein the elongation to break is over 20 %.
Elongation to break is measured according to test method ASTM D882.
The glove of claim 9 wherein the glove has an elongation to break of it least 650 %.
Elongation to break and tenacity were measured according to ASTM method D2256.
The glove of claim 8 wherein the glove has an elongation to break of at least 650 %.
You'll also be interested in:
Examples of using Break
Show more
First they will break our fingers
And break up with the unloved one
I have made my break from you guys
Examples of using Elongation
Show more
Elongation of the parietal and occipital regions
In order to terminate elongation dephosphorylation must occur
Elongation at half the knot breaking load
