Examples of 'engine idle' in a sentence
Meaning of "engine idle"
engine idle - the engine is running slowly or not in gear
How to use "engine idle" in a sentence
Basic
Advanced
engine idle
If engine idle speed is erratic or acceleration is poor.
Cutting attachment moves at engine idle.
Engine idle is set too high.
By increasing the engine idle speed.
Let the engine idle until it is running smoothly.
Cutting attachment rotates at engine idle.
Engine idle speed too low.
The tines should not rotate during engine idle.
Engine idle stop control device and method.
Release throttle trigger and let the engine idle.
Let the engine idle until it stops to free the carburettor.
The cutting attachment must never rotate at engine idle speed.
Engine idle speed.
Make sure the cutting attachment does not rotate at engine idle speed.
The engine idle speed is increased by turning the screw clockwise.
See also
Release spray gun trigger and let engine idle for two.
Engine idle running.
This predetermined level is less than the engine idle speed in this example.
The engine idle speed is the only adjustment for the operator.
Release the throttle lever to run the engine idle and then squeeze the.
The engine idle speed is automatically reduced when the trigger is released.
Release the control lever to run the engine idle and then squeeze the.
Let the engine idle for a few minutes and then turn it off.
Another potential benefit may be a slightly higher accessory speed than the engine idle speed.
The correct engine idle speed also provides air flow to maintain engine cooling.
With this carburetor it is only possibleto adjust the engine idle speed within fine limits.
Set the vehicle engine idle revolutions after previous heating up the engine to working temperature.
For vehicles controlled by an advanced emission control system, at engine idle.
Letting the engine idle for a long time when the vehicle is stopped causes pollution.
Start your car and let the engine idle for about 5 minutes.
Engine idle is too low Follow the instructions to increase idle speed.
Engine-stop period is short or time until next engine idle stop is long.
The engine idle speed is set to the manufacturer 's specification.
This can improve the fuel consumption, for example, in an engine idle condition.
To make the engine idle at a lower speed, rotate the idle adjustment.
Methodology to determine the co2 savings of the use of the engine idle coasting function.
Engine idle speed and ignition timing settings are according to the manufacturer 's recommendations.
The cylinder ( s ) operating under normal conditions may also regulate the engine idle speed.
If the engine idle speed does not slow down automatically, have the vehicle checked.
The cutting attachment must NEVER rotate at engine idle speeds!
To increase the engine idle speed, or anti-clockwise to decrease the engine idle speed.
Use a tachometer, if one is available, to set engine idle.
To adjust the engine idle speed, rotate the idle speed adjustment screw on the carburetor.
These measurements have to be made at engine idle speed . 3.
To make the engine idle at a higher speed, rotate the Idling Adjustment.
The engine should not stall ( stop running ) at engine idle speed.
Let engine idle for about 3 minutes for warm-up.
In addition they have managed to reduce engine idle time by 10 million minutes.
The engine idle speed is set to the manufacturer & apos ; s specification.
Turn the idle speed screw in ( clockwise ) to increase the engine idle speed.
You'll also be interested in:
Examples of using Idle
Show more
This warm idle speed shall be measured
Better she works than stays idle
And an idle life can not be pure
Examples of using Engine
Show more
I started the engine and sped off
An engine shall be remapped prior to a test cycle if
Always stop the engine before unclogging
