Examples of 'entrapment protection' in a sentence
Meaning of "entrapment protection"
entrapment protection: This phrase typically refers to measures or mechanisms put in place to prevent or defend against being trapped or caught in a harmful or disadvantageous situation. It could be used in legal contexts, cybersecurity, or physical safety scenarios
How to use "entrapment protection" in a sentence
Basic
Advanced
entrapment protection
Wiring for entrapment protection device to reverse.
Some wiring types will require an optional monitored entrapment protection device.
All entrapment protection devices must be unobstructed.
Liftmaster monitored entrapment protection lmep.
Additional entrapment protection devices may be wired to the expansion board.
To remove and erase monitored entrapment protection devices.
Cleared when entrapment protection device is cleared or connected.
Property owners are obligated to test entrapment protection devices monthly.
Remove the entrapment protection device wires from the terminal block.
The installer is required to install additional entrapment protection devices in each entrapment zone.
Advancements in gate operator technology have increased safety features and improved entrapment protection.
Refer to the specific entrapment protection device manual for more information.
Gate operators will now monitor for fault conditions of external entrapment protection devices.
Use only LiftMaster approved entrapment protection devices refer to the accessory page.
The same type of device shall not be used for both entrapment protection means.
See also
Test all controls and entrapment protection devices to make sure they are working properly.
Recommended installation, b2 wiring type with monitored entrapment protection device.
Locate entrapment protection devices to protect in BOTH the open and close gate cycles.
ALL gate operator systems REQUIRE two independent entrapment protection systems for each entrapment zone.
Entrapment protection devices MUST be installed to protect anyone who may come near a moving gate.
Refer to the Entrapment Protection section.
Always setup the operator system to the site requirements, including all necessary entrapment protection devices.
Check all Entrapment Protection Device inputs for an active sensor.
The CLOSE EYES / INTERRUPT input is for photoelectric sensor entrapment protection for the close direction.
Two monitored safety entrapment protection devices must be installed at each entrapment point, including.
Must have at least one LiftMaster Monitored Entrapment Protection ( LMEP ) device installed.
No entrapment protection device present - A sensing device is required to close via constant pressure.
Non-monitored entrapment protection device.
Entrapment protection devices MUST be installed to protect anyone who may come near a moving gate / door.
Wrong setting of door or entrapment protection system / Reset and reprogram.
Entrapment Protection Device is removed, the operator will go into a Restricted Close mode.
NOTE, Only one monitored entrapment protection device may be wired to each input.
Entrapment protection devices remote controls 315mhz.
Check door for proper functioning and entrapment protection system / Program door operator / Reset.
A LiftMaster Entrapment Protection ( LMEP ) Device is recommended for the following wiring types.
After ANY adjustments are made, the entrapment protection device MUST be tested.
Check all Entrapment Protection Device inputs for a “ stuck on ” sensor.
Type A Inherent ( built into the operator ) entrapment protection system.
A LiftMaster Monitored Entrapment Protection ( LMEP ) Device is required for most wiring types refer to page 19.
Monitored Dual-Sided Photo Eyes ( CPS-OPEN4 ) Provides primary entrapment protection on doors up to 45ft wide.
You'll also be interested in:
Examples of using Protection
Show more
Legal protection of women against acts of discrimination
Legislative and judicial protection against discrimination
The protection and defence of human rights
Examples of using Entrapment
Show more
Wiring for entrapment protection device to reverse
Use tacks or staples to permanently attach entrapment
All entrapment protection devices must be unobstructed
