Examples of 'excess adhesive' in a sentence
Meaning of "excess adhesive"
Excess adhesive: This phrase suggests having more adhesive or sticky substance than needed or desired. It could refer to a situation where too much glue, tape, or other sticky material has been applied
How to use "excess adhesive" in a sentence
Basic
Advanced
excess adhesive
Excess adhesive is a waste of material and time.
Wipe away any excess adhesive.
Excess adhesive was then removed using a spatula.
Swab away any excess adhesive.
Excess adhesive is removed from the incision.
Immediately remove any excess adhesive using a damp natural sponge.
Excess adhesive that squeezes out is removed.
Remove excess adhesive.
Excess adhesive may be removed with a gentle wipe of a tissue.
Silicone paper at the end was used to catch the excess adhesive.
Scrape excess adhesive with a putty knife.
A further desirable attribute would be the ability to remove excess adhesive material when required.
Remove the excess adhesive before drying.
Apply one wrap of sheeting around the pipe to protect the pipe from excess adhesive.
Clean any excess adhesive before allowing to dry.
See also
In some embodiments, these adhesive strips are drip-dried to remove excess adhesive.
Wash off excess adhesive with clean water.
Sticks to the widest variety of packaging no matter the surface -- and without excess adhesive.
Wipe off excess adhesive immediately using a cloth.
Important, do not use more glue than is necessary, as excess adhesive just adds unnecessary weight.
The excess adhesive remains in the panel bearing.
A further improvement included removal of excess adhesive immediately without disturbing the bond.
The excess adhesive was wiped off.
While the glue is still wet, wipe off excess adhesive with a piece of kitchen paper.
Excess adhesive on the outer portion of the cornice or coving is removed.
As the strips were removed, excess adhesive was doctored off with glass rods.
The excess adhesive is then received on the adhesive receiving element.
Advantageously, said metering blade comprises an edge which removes excess adhesive from the adhesive cylinder.
Wipe away excess adhesive right away before it sets.
Groove 59 is provided as an overflow receptacle for excess adhesive.
This excess adhesive can then be removed with suitable means.
Here again, the rod 78 is rotated to keep it from accumulating excess adhesive.
Excess adhesive that squeezes out of the edges is removed prior to curing.
Permabond CA Solvent 100 is extremely effective for dissolving cyanoacrylate bonds or removing cured excess adhesive.
Cut off the excess adhesive with either a razor blade or a scissors.
A recess 38 which takes up excess adhesive is provided in the flange 14.
The excess adhesive is squeegeed off, leaving islands of adhesive on the template.
Remove any excess adhesive with a damp cloth before the surface dries.
Excess adhesive is removed and the slide surfaces are cleaned with a non-linting tissue.
The drains exit excess adhesive for pumping back into a suitable glue reservoir.
Excess adhesive was dumped through a dump valve ( not shown ) by the pressure generated in extruder 20.
This will prevent any excess adhesive from falling from the ceiling and ruining your carpeting.
Ensure no excess adhesive runs into the union proper affecting the sealing or removal abilities.
Remove any excess adhesive with a cloth and fix the rear panel foil with adhesive tape.
The excess adhesive 18 is collected in a collecting chamber.
You'll also be interested in:
Examples of using Adhesive
Show more
Jeffrey applied adhesive plastic to his window
Adhesive surface only bonds on one side
Transmitter with adhesive tape for affixing
Examples of using Excess
Show more
Wipe off any excess or spilled oil
Excess force may damage the mechanism
You do not have excess lizard spirit
