Examples of 'excess cable' in a sentence
Meaning of "excess cable"
excess cable: This phrase refers to an extra length of cable that is left over after all necessary connections have been made. It typically occurs when installing electrical or telecommunications systems and may need to be managed or stored for future use
How to use "excess cable" in a sentence
Basic
Advanced
excess cable
Wind excess cable beneath the stand.
Do not bundle or roll up excess cable.
Cut off excess cable and wire.
Another handy accessory is a place to store or wrap the excess cable of the headphones.
Store excess cable by winding it into the base.
Tighten the cable ties securely and cut off any excess cable tie ends.
Cut off any excess cable tie ends.
Excess cable must be routed in wavy lines without looping.
Cut off excess cable tie.
Excess cable can be stored in the housing by winding it up in a spiral.
Trim any excess cable.
The excess cable should be attached directly below the antenna.
Carefully feed the excess cable back into the wall.
Leave excess cable so that the electrical box cover can be suspended below the.
Secure the bike mount firmly and cut off any excess cable tie ends.
See also
Wrap the excess cable around the clip.
Secure the sleeves BEFORE trimming the excess cable.
Feed any excess cable back into the drum.
Adjust the length of the cable, cut off the excess cable.
Carefully tuck excess cable in the console mast to avoid damage.
The base is equipped with cord storage, where excess cable lengths can be coiled.
Bundle any excess cable together and ensure that it does not.
When wearing low shoes, tuck the excess cable into your socks.
Do not feed excess cable into a lighting fixture housing or junction.
Conversely, when the moving station moves closer, the winder absorbs the excess cable.
Pull out excess cable from drum allowing access to cable bracket.
Tighten the loop so the coupler can move freely, but will have little excess cable.
Wind up excess cable and secure in a suitable location using cable binders.
Use the cable cleat ( holder ) to store the excess cable section.
Solutions for concealing excess cable length based on suitable housings are also provided.
Any excess cable that extends beyond the back end can then be cut and removed.
After installation, coil excess cable in the AquaRite Pro enclosure.
If the excess cable of this appliance is damaged, it has to be.
Measure ( if needed ) and then cut excess cable from bare wire end of cable.
Store excess cable in the storage net of the storage bag 5.
It was about 2-3 feet of excess cable for my situation.
Tuck excess cable length inside the flue as it 's lowered into position.
Carefully feed any excess cable and air pipe back through the gland.
Coil excess cable length within 6 ” from the fixture ground stake.
Can I hide excess cable in the base?
Wrap any excess cable neatly into the main vertical cable tray, and " zip-tie " in place.
Note Bundle the excess cable and secure it under the cable clips.
Thus, in a closed state, excess cable length is stowed away in the mounting frame 10.
You'll also be interested in:
Examples of using Excess
Show more
Wipe off any excess or spilled oil
Excess force may damage the mechanism
You do not have excess lizard spirit
Examples of using Cable
Show more
Secure the coaxial cable to the ceiling
A cable tie is provided with the appliance
Use plenum rated cable where it is required
