Examples of 'excess wire' in a sentence
Meaning of "excess wire"
Excess wire is surplus electrical wiring that is not needed for a particular purpose
How to use "excess wire" in a sentence
Basic
Advanced
excess wire
Leave all excess wire in an orderly manner.
Some will automatically cut any excess wire off.
Push excess wire back into wall.
Be sure that equipment is turned off and excess wire is cut off.
Cut off the excess wire if necessary.
This requires reversible type wire propelling means together with a store for receiving excess wire.
Trim any excess wire using side cutters.
When hard wiring, do not leave excess wire in range.
Keep excess wire in the base of the unit to a minimum.
After that secure and trim the excess wire and then straighten the beams.
Push excess wire back into the wall opening.
If needed, use the included adhesive strip to hold excess wire in place.
Push any excess wire through the escutcheon plate.
Then screw down the screws, and trim off the excess wire.
The trimming of such excess wire needlessly wastes material.
See also
The excess wire that is released becomes deposited irregularly on the core.
When installed, ensure that any excess wire is contained, preventing it from making.
The excess wire will be bundled inside the receiver box.
Note, It is advisable to remove excess wire after moving light.
Push any excess wire into wall and against mounting.
When installing Permanent Wiring, do not leave excess wire in range compartment.
Push any excess wire back into the electrical box.
Any excess wire or fiber is then severed from the preform.
Trim the excess wire from the tag end eye.
All excess wire and connections must be placed back in the hopper.
Cut off the excess wire that extends past the end of the nozzle.
Guide excess wire back through the hole in inlet bracket and flanged fitting.
Then snip off the excess wire at the bottom of the bearing and file flat.
Coil the excess wire and position away from moving parts and cabinet contents.
Cuts excess wire in one operation, fast and easy.
Any excess wire must be gathered up into the helmet, beneath the padding.
Cut off excess wire and strip back insulation ½ from end of wire.
To wind in excess wire pathway and provide visual and audible feedback on closure, removable.
Removing excess wire mesh screen from the longitudinal edges of the impregnated wire mesh screen ;.
Note, Feed the excess wire back through the wire hole as you attach the speaker.
