Examples of 'exit temperature' in a sentence
Meaning of "exit temperature"
exit temperature - This phrase refers to the temperature indicated when leaving a particular area or environment. It is often used in the context of buildings, vehicles, or controlled settings to measure the external temperature
How to use "exit temperature" in a sentence
Basic
Advanced
exit temperature
Exit temperature of the first reactor.
The concentration of supercoiled plasmid as a function of exit temperature.
Water exit temperature in the torch.
High pressure compressor exit temperature.
Uniform exit temperature profile.
Extrusion speed is also limited by the profile exit temperature.
Coolant exit temperature.
The yield of supercoiled plasmid as a function of exit temperature is shown.
The exit temperature should be high enough to merely avoid precipitation.
Both the screw speed and the exit temperature were considered excessive.
Exit temperature is dependent on the turbine upper temperature limit depending on the material.
About nine minutes twenty seconds to bring the parts back to their exit temperature.
The exit temperature from the pelletizer decreased with the addition of more moisture.
The working fluid then passes through the receivers which heat it to its exit temperature.
Exit temperature of the first Test.
See also
Figure 4 illustrates the concentration of supercoiled plasmid as a function of exit temperature.
As a result, the exit temperature and gas composition are coupled.
Increasing overall pressure ratio implies raising the high-pressure compressor exit temperature.
The gas exit temperature is primarily adjusted vía the re-circulated gas flow.
A which is quite stable according to the exit temperature of the non-condensables.
If the exit temperature is maintained below the line A-B in Fig.
Calculating the temperature differential by subtracting the exit temperature from the entrance temperature ;.
The exit temperature of the drying gas is measured by thermocouple 34.
For example when the exit temperature Tu is too high e . g.
FIG . 4 shows results of FCG tests on a plate rolled with a lower exit temperature.
Thermocouple ( s ) may monitor the exit temperature at the catalyst exit.
The mandrel 24 inputs heat, if necessary, to warm the fluid to the desired exit temperature.
The combined produced water and cooling water stream exit temperature will not exceed 25 ° above ambient.
Product exit temperature and moisture content are shown in Table 25.
This corresponds with a lower necessary exit temperature from the furn ace of approx. 100 C.
The exit temperature of the pellets is preferably about 50°C or less.
Engine four, tie-tube exit temperature on the Russian ship.
At low speeds ( 8m/min ) there was no blistering, irrespective of the pre-heat exit temperature.
The thermometer ( 11 ) enables the exit temperature of the liquid to be monitored.
The exit temperature of the composition was 15 °C.
The flow rate was adjusted in order to maintain an exit temperature of 10 to 20°C.
Shows the exit temperature of the refrigerant over time, Fig . 6.
Typically, 140 °C is selected as a suitable exhaust flue gas exit temperature.
An exit temperature during the pulse combustion drying process may be 82 ° C. or less.
A first reactor exit temperature below 210°C is desirable to minimize acetic acid burn.
The exit temperature and pressure will therefore typically be of the order of 300°C at 12 bar.
The exit temperature of the emulsion after the last C-unit was 2°C.
The exit temperature of the gases from the engines, EGT ( Exhaust Gas Temperature ) ;.
You'll also be interested in:
Examples of using Exit
Show more
Please exit for the next customer
I just saw you exit that bar
Exit all running programs before installation
Examples of using Temperature
Show more
Manufacturer of the separate temperature measuring equipment
Actual temperature below low temperature value
Select the desired temperature with and
