Examples of 'fan stops' in a sentence
Meaning of "fan stops"
Fan stops refers to the situation when a mechanical or electrical fan ceases to function or operate. It indicates that the fan has come to a halt or has stopped spinning, which can be due to power failure, malfunction, or intentional shut-off
How to use "fan stops" in a sentence
Basic
Advanced
fan stops
Wait until the fan stops rotating.
Indoor fan stops occasionally during heating operation.
After this time the fan stops automatically.
Fan stops during heating operation.
The indoor unit fan stops and is displayed.
Only remove the plug from the mains socket when the fan stops running.
Convection fan stops during a convection bake cycle.
You may unplug the AC power cord before the fan stops.
The fan stops when the door is open.
Unplugging the AC power cord before the fan stops may cause a malfunction.
The fan stops when the compressor stops.
During convection cooking the fan stops when I open the door.
The indoor fan stops occasionally during cooling operation.
If you deactivate the appliance, the cooling fan stops.
The indoor or outdoor fan stops running when defrosting.
See also
The fan stops when you open the door and restarts immediately when you close it.
Heating ready indoor fan stops while this is displayed.
The fan stops when the door opens and restarts immediately after the door closes.
While this indication is displayed, the indoor fan stops.
When the fan stops one can get past.
If you switch off the appliance, the cooling fan stops.
Indoor fan stops occasionally during automatic fan speed setting.
Wait for about 1 minute until the cooling fan stops.
The indoor unit fan stops and the remote controller displays.
When the AC Cord is unplugged, the internal cooling fan stops op er at ing.
The indoor unit fan stops and the remote controller display shows.
While this indication is displayed, the indoor fan stops or the mode enters in LOW.
The supply air fan stops if the supply air temperature drops further.
Make sure ON / OFF lamp goes out when the fan stops.
If a fan stops operating due to failure or removal, the system continues to run.
Approx . 4 min after the last welding the fan stops and starts automatically by a new welding.
When the fan stops after approximately 5 minutes the control and speed setting process is complete.
While is displayed, the indoor fan stops or the mode is Low speed mode.
The fan stops prematurely - Check that the air inlet grills are not blocked.
During Automatic Airflow Volume setting, indoor fan stops occasionally.
Once the fan stops running, you can then unplug the heater.
If the door is left open for longer than 30 seconds during baking, the fan stops.
When the fan stops running, the STANDBY indicator lights in red.
What, Tour around Paris with fan stops.
Fan stops at thermostat OFF cooling / heating.
The extractor fan stops after 15 minutes and the lighting switches off.
Fan stops during thermostat OFF Cooling · heating.
The extractor fan stops after 15 min. and the lighting switches off.
Fan stops during start-up or heating.
My PWM fan stops regularly - is it defective? read.
The fan stops and the ON / STANDBY indicator changes from flashing green to remaining red.
