Examples of 'field wiring' in a sentence
Meaning of "field wiring"
Field wiring refers to the process of installing electrical or communication wiring systems in industrial or construction settings. It includes the installation, connection, and routing of wires to facilitate the transfer of electricity or data signals in buildings, machinery, or equipment. Field wiring typically involves skilled electricians or technicians who ensure proper wiring installation according to safety standards and building codes
How to use "field wiring" in a sentence
Basic
Advanced
field wiring
Field wiring through their appropriate conduits.
To permanently connect to household or field wiring.
Connect field wiring as shown on wiring diagram on unit.
A disconnect means must be provided for field wiring.
Field wiring pathway low voltage.
Remove the cover from the field wiring.
Field wiring insulation lenght to be removed.
An equipment grounding terminal is provided in the field wiring compartment.
Field wiring see table below.
The terminal blocks allow easy connection of field wiring.
Check field wiring for damage and replace if necessary.
Only qualified electrical personnel should perform field wiring procedures.
Replace the field wiring compartment cover and the grease.
Refrigerant can not be charged until field wiring has been completed.
Run field wiring from circuit breaker box to wall thermostat.
See also
The mains input connector is not acceptable for use as field wiring terminals.
Most field wiring on the indoor unit side is to be made on the.
Remove the wire pigtail from the line side of field wiring block and discard.
Make sure the field wiring complies with the applicable legislation.
Thread the power supply cable through the wiring knockout into the field wiring compartment.
All field wiring must have insulation suitable for rated voltages.
Be sure to follow all local and National electrical codes when making field wiring connections.
Those connections where field wiring is required are discussed in the following sections.
ERLQ units control the bottom plate heater internally field wiring NOT required.
All field wiring must be installed in accordance with the national wiring regulation.
Connect the electrical conduit to the Field Wiring Compartment using listed conduit fittings.
Field wiring must be properly sized to carry the amperage in accordance with the NEC.
Does not have ductwork blocking your access to the Field Wiring Compartment.
Connect the field wiring to the heater wiring as shown in the wiring diagram.
Note, only relevant field wiring is shown.
Route all field wiring away from moving parts within the hand dryer.
Determine which knockout in enclosure will be used for field wiring and remove see figure 1.
Remove the field wiring from the SIC terminals and short either the.
Place the metal control box shield over the thermostat, switch and field wiring boxes.
All field wiring must conform to NEC guidelines as well as state and local codes.
This allows for quick and easy connections for prototypes, field wiring or even permanent installations.
Use the field wiring entries to bring the wiring into the MVS sensor electronics head.
Determine which knockout in enclosure will be used for field wiring and remove see Fig 1.
Top-mounted field wiring compartment is easier to access and connect.
Setup: Connect the following field wiring.
Remove the cover from the Field Wiring Compartment with a phillips screwdriver.
Field wiring must comply with applicable codes, ordinances and regulations.
Method B - To permanently connect to household or field wiring.
Note, only relevant field wiring and not all implemented parts are shown.
Method B - Permanent connection to household or field wiring.
For field wiring information, please refer to the instructions attached to inside of front cover.
Disconnect power before installation, servicing, maintenance or field wiring.
For type of protection “ e, ” field wiring conductors shall be copper.
The field wiring assembly 112 provides excitation to the probes and receives signals from the probes.
Make wiring connection, attaching field wiring to two (2) black.
You'll also be interested in:
Examples of using Wiring
Show more
Wiring is pulled trough column and base
Alterations of the wiring diagram are now allowed
Wiring should be carried out by qualified personnel
Examples of using Field
Show more
Reserve for field accommodation authorized level
Future strategy document in the field of the
In the field of epidemic surveillance and control
