Examples of 'fill tube' in a sentence
Meaning of "fill tube"
The phrase 'fill tube' typically refers to a tube or pipe that is used to fill a container or reservoir with a liquid or substance. It is commonly used in contexts such as filling gas tanks, oil drums, or water tanks, where a tube or pipe is inserted into an opening to allow for the transfer of the substance
How to use "fill tube" in a sentence
Basic
Advanced
fill tube
Attach air pump to fill tube on tire.
Hold the fill tube with hand to stabilize as needed.
Remove and reinsert product on fill tube.
Use an oil fill tube that will go into holes so that air can escape.
Do not remove plastic fill tube.
Lubricate top of fill tube stem with a small amount of petroleum jelly included in carton.
Difficult to insert or remove fill tube from valve.
The fill tube section 42 is centered on a fill tube axis AF.
Install drain plug and fill tube cap.
Fresh PBS was added to fill tube to the top, and centrifugation was repeated.
Add fluid using the extension tube as a fill tube.
A liquid header is used to supply a fill tube for each can to be filled.
A cavity below the septum leads to the fill tube.
Allow the oil to drain from the oil fill tube into an appropriate container.
Put petroleum jelly in fill port opening and or fill tube.
See also
Resin may be connected to the fill tube on the end shown with a curved neck.
You can check the level of oil in the fill tube.
A compressed gas fill tube 78 secures to the canister end plate 52.
Filling takes place through a single fill tube and nozzle.
This fill tube or port 216 may later be sealed in a known manner.
Well water fill tube.
Gently push the RAPIDROLLER down until it bottoms on the fill tube.
The fill tube port 1414 prevents gas and liquid from passing therethrough.
Tip unit on its side to drain through the oil fill tube.
The fill tube 22 can then be sealed in the conventional manner to close the cell 10.
Lift RAPIDROLLER slowly off fill tube.
The fluid in the fill tube 36 then drains through the drain line 26 into a container.
Add TNE if needed to completely fill tube.
Fill tube to top with n-butanol saturated with 1M NaCl, extract.
In this situation, this pipe extends the fill tube.
Fill tube to top with n-butanol saturated with 1M NaCI, extract.
Thus, all air is expelled from the fill tube and syringe.
For instance, the fluid reservoir is an elongated balloon placed along the fill tube.
In figure 2F an alternative fill tube shape 114 is shown, which in this case is circular.
NOTE, Inside each fitting is a plastic fill tube.
In one construction, the fluid reservoir and fill tube are co-extruded.
Opposite longitudinal edges of the film are brought together around the fill tube 106.
Indeed, the protective sheath, fluid reservoir and fill tube may be co-extruded.
They are symmetrical with respect to the plane of symmetry S of the fill tube 114.
In this alternative technique, the seal 62 and the fill tube 64 need not be used.
The upper level sensor 34 defines an upper level of fluid in the fill tube 36.
The oil must be drained from the top oil fill tube E, Figure 8.
Hold the RAPIDROLLER at a 45 degree angle and place the fill valve ( 1 ) over the fill tube.
Once chamber 104 has been filled with a pressurized gas, the fill tube 96 is sealed by welding.
Push in until tight and to the ridge of the fill tube Fig . E.
A supply of inert gas is still supplied vía the feed fill tube 96.
Of the film may be brought together around a product fill tube 106.
A positive sealing inlet valve assembly for a fuel tank fill tube ( 12 ) comprising,.
The fill cap 82 is in sealing engagement with a fill tube 84 FIG.
