Examples of 'fl oat' in a sentence
Meaning of "fl oat"
To rest or move on the surface of a liquid or in the air without sinking
How to use "fl oat" in a sentence
Basic
Advanced
fl oat
Install the fl oat assembly to the fuselage.
Do not allow water infl ow to affect fl oat.
Insert the fl oat below this tab.
The vacuum grid is clogged or the fl oat is closing.
Refer to the fl oat manual for installation instructions.
Recess for the red fl oat.
A rear fl oat mount is included with the aircraft.
Tighten to keep fl oat from turning.
Clean the grid and check the fl oat.
Do not remove the fl oat or silver ion cartridge.
Attach the fi rst strut to the aluminum fl oat mount.
Ball in the fl oat is blocking air fl ow.
Never pick up liquid without the fl oat body in place.
Install fl oat valve and fi ii pan.
The vacuum grid is clogged or the fl oat is stuck closed.
See also
Connect to fl oat fi tting and tighten until water tight.
Insert the tab of the fl oat into the hole.
Tank full fl oat switch closing off the suction opening.
Interest earned from investing the fl oat generates financial revenue.
A fl oat valve shuts off suction when the tank is full.
Then reinstall the fl oat valve to the fl oat basket.
The arrow in the photo points toward the front of the fl oat.
Then secure the fl oat basket by turning it to the right.
The pendant version of the elegant escape sign luminaire seems to fl oat.
Sweep boom with end fl oat foam or air fi lled.
The fl oat will stop the fl ow into the recovery tank.
Each item should be able to fl oat freely without touching another.
The machine will not pick up water with the fl oat closed.
Thread the fl oat strut mounts into the holes in the fuselage.
Inser t the tab on the other side of the fl oat into the hole.
Connect the fl oat servo lead to the rudder extension in the fuselage.
The machine will not pick up water or scrub with the fl oat activated.
Never pick up liquid without the fl oat system installed in the machine.
Financial revenue generated by the fl oat 7.
Lift and release the fl oat switch to activate the standby pump.
Never tamper with or attempt to defeat the water level safety fl oat switch system.
Also make sure the ball fl oat in the recovery tank is clean.
Remove the covering from the fuselage for the eight fl oat strut mounts.
Connect the extension from the fl oat servo to the extension at the fuselage.
To install the fi lter, slide it over the fl oat cage.
Insert the struts into the fl oat slots on the bottom of the fuselage.
See chapter 4 for mounting the fl oat system.
Align and mount the fl oat set assembly to the bottom of the fuselage.
Install the tank, reconnecting hoses and plugging in vac motor and fl oat switch connectors.
If the recovery tank fl oat switch becomes dirty it can impair its proper operation.
See Figure 6 for the correct orientation of the switch fl oat arm.
Make sure there is adequate room for fl oat switch to move freely during operation.
Plug the fl oat switch, pump, and charger into the control box.
Do not remove the Styrofoam in the fl oat which is located in the bucket.
Has the fl oat inside the humidifying tray come off?
