Examples of 'flame height' in a sentence
Meaning of "flame height"
Flame height refers to the vertical distance from the base of a flame to its highest point. It is typically measured in meters or feet and is used to assess the intensity and potential danger of a fire. Flame height can vary depending on the fuel source, combustion conditions, and environmental factors
How to use "flame height" in a sentence
Basic
Advanced
flame height
Adjustable flame height for varying conditions.
Suggested settings for flame height table.
Flame height modulates between high and low.
Press button to increase the flame height.
To increase flame height press and hold button.
Adjust control knob to desired flame height.
The flame height is not expected to change significantly.
Loosen screw to increase the flame height.
The flame height can be adjusted as you wish.
O excessive and sudden increases in flame height.
The flame height can then be controlled by the remote.
Tighten screw to reduce flame height.
Adjust the flame height to suit by turning the knob.
Turn left to increase flame height.
The flame height can be adjusted in the following manners.
See also
Sudden drop in gas flow or reduced flame height.
Adjusting the minimum flame height of the main burner.
Flame height was measured in inches.
Adjust controls to desired flame height.
Flame height is regulated automatically to reach the set night temperature.
Turn right to decrease flame height.
Flame height is regulated automatically to reach the set daytime temperature.
Setting proper burner flame height.
The flame height is increased by pressing and holding down the button.
Manually decrease or increase flame height.
The flame height is then automatically adjusted to achieve the set temperature.
Turn front of grill to face wind or increase flame height.
The flame height is proportional to the gas flow as shown in the figure.
Following are some basic rules for selecting flame height.
Flame height control is factory set to the maximum and requires no manual adjustments.
At the desired flame height.
Increase in jet velocity after critical limit results in decrease of the whole flame height.
This allows you to maintain optimal flame height while slowly melting an even wax pool.
Turn front of grill away from wind or increase flame height.
A lower value flame height and higher mass retention indicate desirable performance characteristics of a flame retardant.
This is particularly important for adjusting the flame height accurately.
Test Flame Height can be adjutable.
The adjustment screw is set so as to provide the maximum flame height.
Maximum flame height in cm - duration of flame in seconds.
Press the up arrow key once to increase flame height by one step.
O measure the flame height at the minimum setting ;.
The test lighters may then be actuated to test for flame height.
Adjust the flame height by moving gas control lever between left /.
The distribution of clear glass over the burner will influence flame height.
With both types of lighters, the maximum flame height is required to be controlled.
Other conventional lighters utilize a fixed fuel delivery mechanism to effect a fixed flame height.
To decrease flame height or to set appliance to pilot flame, press and hold button.
Exhibits abnormal burning characteristics observed during flame height and inversion tests.
Thus, an acceptable flame height is above a quarter of an inch and below three inches.
Visually check burner flames at each use and make sure the flame height matches illustration.
You'll also be interested in:
Examples of using Height
Show more
Height and weight are about the same
The armrest can be height adjusted as follows
Height and depth adjustable steering wheel
Examples of using Flame
Show more
Flame retardant materials bear the mark
Envision the flame burning within you
Flame disk or combustion heads dirty or worn
