Examples of 'flame length' in a sentence
Meaning of "flame length"
flame length: The measurement or extent of a flame, typically referring to the distance between the base and the tip of a visible flame
How to use "flame length" in a sentence
Basic
Advanced
flame length
Relates containment job to flame length.
Flame length is shortened in proportion to the flare angle of the impeller.
An adjustable flame length.
The principle advantage of the embodiment described above is low NOx with reduced flame length.
This solves the problem of reducing flame length in a low NOx burner.
Although the flame length is somewhat shortened, a sufficient length is obtained.
This can lead to a mishap if the flame length is set too long.
The approximate flame length of the broil burner is 1 inch distinct inner, blue flame.
The lighter was used and the change in flame length after lighting was measured.
Reference numeral 8 denotes a knob for regulating the flame length.
It also permits adjustment of the flame length by adding oxygen to the air flow.
Types of gas, by replacing the corresponding injectors and adjusting minimum flame length suitable.
A law measuring flame length evolution in the range 0.
The reduced fuel jet momentum tends to reduce flame length for two reasons.
The flame length change pattern was similar to that in Test 1.
See also
Impulse staged burners also make it possible to vary flame length independently of operating power.
These serve to deflect the fuel jet, reducing axial fuel momentum and reducing flame length.
The relationship between the temperature and the flame length was then obtained by repeated testing.
To decrease flame length and temperature, move the Flame Control Slider to the left.
However, the stability effect is detrimental to the flame length and luminosity.
The approximate oven burner flame length is 1 inch distinct inner cone of blue flame.
With this type of firing, combustion is extremely rapid, and short flame length results.
Also in this test, the flame length change pattern was similar to that in Test 1.
Also, when the inner oxidant flow was increased, the flame length and luminosity decreased.
Adjustment of the flame length / temperature can be made by adjusting the Flame Control Slider.
After you ignite the burner in maximum position ; you can adjust the flame length between.
The relationship between the saturated flame length and the projection length is shown in Figure 11.
The flame length varied with gas flow rates and was between 60 to 75 cm.
The Burning Index ( BI ) relates flame length to fire spread speed and temperature.
To increase flame length and temperature, move the Flame Control Slider to the right.
FIG . 9 is a plot of modeling results showing flame length as a function of non-dimensional nozzle length.
Figure 9 a graph showing flame length change property in Test 3, together with a comparative example.
In compiling this data the flame length was adjusted to 25 mm at 20 degrees centigrade.
You'll also be interested in:
Examples of using Flame
Show more
Flame retardant materials bear the mark
Envision the flame burning within you
Flame disk or combustion heads dirty or worn
Examples of using Length
Show more
Tubing length and elevation difference limits
Cut wire liner at the right length
Only the length of the journey differs
