Examples of 'flame sensor' in a sentence
Meaning of "flame sensor"
A flame sensor is an electronic device used in various heating systems, such as furnaces or water heaters, to detect the presence or absence of flames. It is designed to ensure that the burner flames are ignited and kept burning, as well as to provide safety measures in case of flame failure. 'Flame sensor' is an essential component in these systems to monitor and control the flame
How to use "flame sensor" in a sentence
Basic
Advanced
flame sensor
Remove flame sensor and clean or replace it.
Disconnect one of the flame sensor wires.
Your flame sensor may need a cleaning.
System for processing a flame sensor output signal.
Flame sensor was cleaned up.
The boiler is fitted with an ionised flame sensor.
Incorrect flame sensor ionisation probe.
Be careful when handling the igniter and flame sensor.
Inefficient flame sensor ionisation probe.
Call a professional to inspect and clean your flame sensor.
Confirm the flame sensor is in its proper position.
The pilot flame should be approximately 2 inches long, extending past the flame sensor.
Mount the flame sensor cover to this support plate.
A complete BurnerPRO system consists of the housing, the wiring frame and the corresponding flame sensor.
This allows the flame sensor to heat up and operate the safety device.
See also
ODS Operation, Burner porting " blows " out causing flame sensor to cool, shutting down heater.
The flame sensor cable must be routed through the slotted cover to the outside.
Thermostat Flame sensor.
Remove the flame sensor and the silicone hose from the pressure pipe as well.
Replace igniter / flame sensor if necessary.
The flame sensor confirms that the pilot has been lighted and allows burners to ignite.
F03, not ignited Ignition failed, flame sensor does not register sufficient rise in temperature.
Flame sensor defective Acknowledge the error message.
Sensitive IC flame sensor will cut gas supply if flame goes out.
Flame sensor electrical connection cut-off.
Note, For testing flame sensor circuit use a micro-amp meter in series with sensor.
Flame sensor indicate start / stop burning.
Be careful as flame sensor is in the 115VAC circuit.
Flame sensor should measure 3 inches from clamp to the end of the terminal connection.
Stuck flame sensor Stuck closed.
Flame sensor ( ionization probe ) position incorrect.
Remove flame sensor from burner compartment 1 screw.
Flame sensor ( ionisation probe ) position incorrect.
Flame sensor ( ionisat ion probe ) inefficient.
Flame sensor ( ionization probe ) inefficient.
The flame sensor current must be steady and at least 1.0 ua.
You'll also be interested in:
Examples of using Flame
Show more
Flame retardant materials bear the mark
Envision the flame burning within you
Flame disk or combustion heads dirty or worn
Examples of using Sensor
Show more
Search for the sensor or check batteries
Sensor readings and radio communications are terminated
An integrated light sensor also measures brightness
