Examples of 'flash head' in a sentence
Meaning of "flash head"
Flash head: This term typically refers to the main or primary light that is used in photography. It is the primary source of light that is aimed at the subject to illuminate it for a photograph
How to use "flash head" in a sentence
Basic
Advanced
flash head
Fuse for halogen lamp in flash head.
The flash head setting can be changed manually.
Stamped into the flash head.
Gently rotate the flash head into the required position.
This is a huge diffuser that mounts directly onto the flash head.
Tilt the flash head up.
Only flash head extension cables with the plug code must be used.
Turns the modeling light on the flash head on and off.
Do not adjust the flash head angle beyond the adjustable range.
Manual zoom allow the user to set the zoom of the flash head.
Gently raise or lower the flash head into the required position.
Snap one side of the diffuser mount into the corresponding flash head mount.
Only light was a flash head with honey comb laying on the floor.
The brightness on the right or left depends on the flash head output switch setting.
The EH Pro Mini flash head cables are screwable with round sockets.
See also
If using the diffuser panel it will drop into position over the flash head.
The maximum load capacity of the flash head must not be exceeded.
You must also adjust the optical Deflector which is in the flash head.
Do not fire the unit while the flash head is touching a person or object.
The flash head can be moved directly at 3 and 4.
Gently push the bounce card back into the flash head if not needed.
When the flash head is tilted 7 will blink.
Press the lock button and adjust the flash head to set the bounce angle.
Adjust the flash head 1 Adjust the flash head to the.
Press the Button to edit the flash head zoom.
Mark blinks, then the flash head is adjusted to an incorrect position.
To choose these positions, move the flash head as shown.
Zooming Flash Head for 5 different positions.
For standard flash shooting, tilt the flash head to the horizontal position.
The flash head can also be tilted down by 7 ° for close-up shots.
The admissible load capacity of a flash head will be controlled by a flash head plug code.
Due to the modeling and flash light, each power pack and flash head emits heat.
With 1 flash head per channel.
Separation, Control unit can be mounted in excess of 500 feet from flash head.
Zoom, Indicates auto or manual flash head zoom and distance.
The flash head of the SB-400 is not set to the horizontal position.
Azoom will work ONLY when the flash head is set to either 0 or -7 degrees.
Depending on the flash head setting, the flash 's Guide Number will be changed.
Before starting up the maximum loading of the flash head must be observed minimum 1200 Ws.
Tilt the flash head 90º and take the shot.
Tilt the flash head 90º upper Horizontal.
