Examples of 'flow condition' in a sentence
Meaning of "flow condition"
Flow condition: In engineering or physics, flow condition refers to the state of a fluid flowing through a system, characterized by factors such as velocity, pressure, and temperature
How to use "flow condition" in a sentence
Basic
Advanced
flow condition
The pseudouniform flow condition is considered in detail.
Viscometers only measure under one flow condition.
The free flow condition is thus avoided.
The device has detected a high oxygen flow condition.
The flow condition within the eddy wake is very turbulent.
The device has detected an impeded oxygen flow condition.
The second flow condition is different than the first flow condition.
This is a low flow condition.
The at least one virtual sensor signal represents a local flow condition.
Woodward created a water flow condition that is easily sculpted by minor external forces.
Current input can be spatially varying for each flow condition.
This is consistent with the high flow condition referred to in the following paragraph.
The valve arrangement may be configured to be lockable in the open flow condition.
The resulting change in flow condition can cause a corresponding orientation of the sample material.
Typical boundary conditions correspond to a no flow condition or a specified net flow.
See also
These variations of the topography initiated a hydraulic jump causing a change in the flow condition.
Measurements of physical fluid flow condition variables by the sensors ;.
The sensor module provides two systems to avoid a free flow condition.
Transmissions of the measured physical flow condition variables to the computer ;.
The valve arrangement may be biased towards the closed flow condition.
The zero flow condition is equivalent to mirror symmetry, the assembly is repeated to infinity.
Panel loads are calculated by implementing their kinematic flow condition on their surface.
Flow condition sensors can be utilized to determine flow rate, leakage, or slurry concentration.
The drum is simultaneously rotated at the required speed to meet the flow condition requirements.
Such a flow condition as depicted in Figure 7 provides two benefits.
Typically this setpoint is determined only for the rated power rated flow condition.
Flow Condition = One, The process will continue when one of the instances is accomplished.
Failure of a typical check valve could result in a higher than specified pressure and flow condition.
Figure 2 shows a normal oil flow condition when the engine / pump are operating.
In each case the rail pressure will stabilize for a given RPM and flow condition.
In a drain phase, the occluded flow condition can represent a flow rate of less than 10 ml / min.
All other conditions were the same as in the first flow condition of this Example.
For convenience, the apparatus will generally be described hereinafter with a top-down flow condition.
If a seal is not maintained, a free flow condition could result.
Figure 1 depicts in a cross-sectional view the operation of the dispenser 20 under a " normal " flow condition.
Essentially, the particles exhibit a spouting-like flow condition in the coating column 28.
It is easy to reach a laminar, or nearly laminar flow condition.
FIG. 18 is a view showing a flowchart of a flow condition judgment process.
As such, the valve arrangement is locked in its open flow condition.
By proper coordination of all of the above parameters, a virtually constant flow condition is feasible.
By proper coordination of these and other mentioned parameters, a substantially constant flow condition is feasible.
Figure 6 is a view similar to Figure 4 showing the dispenser in a high flow condition.
A system according to Claim 1, wherein the second set of criteria includes a low liquid flow condition.
A software algorithm in the I / O Controller code uses these inputs to determine the flow condition.
Liquid entrainment is, in one sense, a dynamic flow condition.
Fig . 1 illustrates the regulator valve in a normal open flow condition.
The overall shaft power consumption of the compressor is 224kW at the maximum flow condition.
Fig . 25 diagrammatically shows this dynamic plasma flow condition.
That is, the biasing arrangement 66 biases the valve arrangement 60 into its closed flow condition.
FIG . 5 is a view similar to FIG . 4 showing the dispenser in a low flow condition.
You'll also be interested in:
Examples of using Flow
Show more
I let the anger flow right through me
The flow of information is a two way street
Insufficient air flow through burn grate
Examples of using Condition
Show more
I am gonna check on the condition of the survivors
But a condition like that can change
I want to check the condition of the item
