Examples of 'gloss values' in a sentence
Meaning of "gloss values"
gloss values: This phrase could refer to the measurements or ratings associated with the level of shine or luster on a surface. It is often used in discussions about cosmetics, paint, or photography
How to use "gloss values" in a sentence
Basic
Advanced
gloss values
Gloss values were taken on all charts as well.
Flexible or plasticized polyvinyl chloride typically has high gloss values.
Gloss values were takcn on all charts as well.
This increase was not sufficient to restore the natural gloss values of the pepper skin.
High gloss values indicate a good stabilization.
The uncoated peppers showed the highest gloss values as compared to the other treated peppers.
The gloss values were measured on a corresponding metallized film.
The same Table also reports the haze and gloss values.
Low gloss values correspond to a high matting effect.
On board trend analysis Gloss values.
The haze and gloss values were of films coated with an antiblock powder of starch.
In many applications, high gloss values are desirable.
The gloss values were determined on the metallized film,.
As required by the market, the composition shows low gloss values.
The various gloss values are given in the following table 1.
See also
The longer the brushing time intervals, the higher the gloss values that were measured.
Film haze and gloss values are comparable to the Ziegler-Natta based films.
The compositions ( sheets ) also have low gloss values.
Also here, the gloss values are not acceptable for today 's automotive interior applications.
In contrast, typical sprayed coatings have gloss values of less than about 150 gloss units.
These gloss values can be found in Table 4.
Test method ASTM D-523 was followed for determining specular gloss values.
Typically, higher gloss values are desirable for top coats and metallic ink applications.
Figure 4 illustrates 60 ° gloss values for the various samples.
The gloss values were measured using a 60 ° geometry.
In the later case, total gloss values are the sum of the individual gloss readings.
The gloss values of coatings remain greater than 80 % after 6 months.
This can be illustrated by gloss values on the electrograined surface, as shown in Figure 5.
Gloss values are given in GU ( Gloss Unit ).
The original gloss values have been measured at an angle of 20 °.
Table, Gloss values of commercially available coated tablets.
As indicated below, the gloss values were measured from a reflection angle of 60 °.
The gloss values reported in Table 2 and the Figure were measured at 60 °.
The gloss values are as follows,.
You'll also be interested in:
Examples of using Gloss
Show more
I have to gloss over the short notice
You can take your lip gloss
High gloss enamel applied to each nail
Examples of using Values
Show more
The measured values shall be plotted on a graph
Date and time revert to default values
Carrying values and estimated fair values
